[PATCH 05/20] ARM: dts: imx6q-dhcom: Add ethernet VIO regulator

[Christoph Niedermaier]

Add VIO regulator that supplies multiple ethernet magnetics and
currently there is no upstream support for that in the networking,
so just keep the regulator enabled always to emulate what other
boards, which have this hard-wired, do. Until there is support.

Signed-off-by: Christoph Niedermaier <cniedermaier at dh-electronics.com>
Cc: Shawn Guo <shawnguo at kernel.org>
Cc: Fabio Estevam <festevam at gmail.com>
Cc: Marek Vasut <marex at denx.de>
Cc: NXP Linux Team <linux-imx at nxp.com>
Cc: kernel at dh-electronics.com
To: linux-arm-kernel at lists.infradead.org
---
 arch/arm/boot/dts/imx6q-dhcom-som.dtsi | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)

diff --git a/arch/arm/boot/dts/imx6q-dhcom-som.dtsi b/arch/arm/boot/dts/imx6q-dhcom-som.dtsi
index d6e41fd4322b..4bf51f3ce003 100644
--- a/arch/arm/boot/dts/imx6q-dhcom-som.dtsi
+++ b/arch/arm/boot/dts/imx6q-dhcom-som.dtsi
@@ -33,6 +33,19 @@
 		reg = <0x10000000 0x40000000>;
 	};
 
+	reg_eth_vio: regulator-eth-vio {
+		compatible = "regulator-fixed";
+		gpio = <&gpio1 7 GPIO_ACTIVE_LOW>;
+		pinctrl-0 = <&pinctrl_enet_vio>;
+		pinctrl-names = "default";
+		regulator-always-on;
+		regulator-boot-on;
+		regulator-min-microvolt = <3300000>;
+		regulator-max-microvolt = <3300000>;
+		regulator-name = "eth_vio";
+		vin-supply = <&sw2_reg>;
+	};
+
 	reg_usb_otg_vbus: regulator-usb-otg-vbus {
 		compatible = "regulator-fixed";
 		regulator-name = "usb_otg_vbus";
@@ -280,6 +293,11 @@
 			MX6QDL_PAD_GPIO_16__ENET_REF_CLK	0x4001b0a8
 			MX6QDL_PAD_EIM_WAIT__GPIO5_IO00		0x000b0
 			MX6QDL_PAD_KEY_ROW4__GPIO4_IO15		0x000b1
+		>;
+	};
+
+	pinctrl_enet_vio: enet-vio-grp {
+		fsl,pins = <
 			MX6QDL_PAD_GPIO_7__GPIO1_IO07		0x120b0
 		>;
 	};
-- 
2.11.0