[PATCH 3/3] dt-bindings: gpio: pcf857x: Convert to json-schema

[Linus Walleij]

On Fri, May 21, 2021 at 9:54 AM Geert Uytterhoeven
<geert+renesas at glider.be> wrote:

> Convert the PCF857x-compatible I/O expanders Device Tree binding
> documentation to json-schema.
>
> Document missing compatible values, properties, and gpio hogs.
>
> Signed-off-by: Geert Uytterhoeven <geert+renesas at glider.be>

(...)
> Perhaps the "ti,pcf8575" construct should be removed, and the few users
> fixed instead?

You would rather list it as deprecated I think?
It is ABI...

> +  gpio-controller: true

So this is implicitly using the generic schema in
/dtschema/schemas/gpio/gpio.yaml

> +  lines-initial-states:
> +    $ref: /schemas/types.yaml#/definitions/uint32
> +    description:
> +      Bitmask that specifies the initial state of each line.
> +      When a bit is set to zero, the corresponding line will be initialized to
> +      the input (pulled-up) state.
> +      When the  bit is set to one, the line will be initialized to the
> +      low-level output state.
> +      If the property is not specified all lines will be initialized to the
> +      input state.

Is this something we standardized or something that should
actually be a custom "nxp," property we just missed it?
(Looks like the latter... oh well, now it is there.)

> +patternProperties:
> +  "^(hog-[0-9]+|.+-hog(-[0-9]+)?)$":
> +    type: object

But this is already in
/dtschema/schemas/gpio/gpio-hog.yaml
for nodename, isn't that where it properly belongs?

I'm however confused here Rob will know what to do.

> required:
>   - gpio-hog
>   - gpios

This is already in
/dtschema/schemas/gpio/gpio-hog.yaml
as well?

Yours,
Linus Walleij