[PATCH 4/4] dmaengine: xilinx: dpdma: Limit descriptor IDs to 16 bits
Laurent Pinchart
laurent.pinchart at ideasonboard.com
Thu May 20 08:24:20 PDT 2021
While the descriptor ID is stored in a 32-bit field in the hardware
descriptor, only 16 bits are used by the hardware and are reported
through the XILINX_DPDMA_CH_DESC_ID register. Failure to handle the
wrap-around results in a descriptor ID mismatch after 65536 frames. Fix
it.
Signed-off-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
---
drivers/dma/xilinx/xilinx_dpdma.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/dma/xilinx/xilinx_dpdma.c b/drivers/dma/xilinx/xilinx_dpdma.c
index 5834f8614a58..6a8bb977fc7a 100644
--- a/drivers/dma/xilinx/xilinx_dpdma.c
+++ b/drivers/dma/xilinx/xilinx_dpdma.c
@@ -113,6 +113,7 @@
#define XILINX_DPDMA_CH_VDO 0x020
#define XILINX_DPDMA_CH_PYLD_SZ 0x024
#define XILINX_DPDMA_CH_DESC_ID 0x028
+#define XILINX_DPDMA_CH_DESC_ID_MASK GENMASK(15, 0)
/* DPDMA descriptor fields */
#define XILINX_DPDMA_DESC_CONTROL_PREEMBLE 0xa5
@@ -867,7 +868,8 @@ static void xilinx_dpdma_chan_queue_transfer(struct xilinx_dpdma_chan *chan)
* will be used, but it should be enough.
*/
list_for_each_entry(sw_desc, &desc->descriptors, node)
- sw_desc->hw.desc_id = desc->vdesc.tx.cookie;
+ sw_desc->hw.desc_id = desc->vdesc.tx.cookie
+ & XILINX_DPDMA_CH_DESC_ID_MASK;
sw_desc = list_first_entry(&desc->descriptors,
struct xilinx_dpdma_sw_desc, node);
@@ -1090,7 +1092,8 @@ static void xilinx_dpdma_chan_vsync_irq(struct xilinx_dpdma_chan *chan)
if (!chan->running || !pending)
goto out;
- desc_id = dpdma_read(chan->reg, XILINX_DPDMA_CH_DESC_ID);
+ desc_id = dpdma_read(chan->reg, XILINX_DPDMA_CH_DESC_ID)
+ & XILINX_DPDMA_CH_DESC_ID_MASK;
/* If the retrigger raced with vsync, retry at the next frame. */
sw_desc = list_first_entry(&pending->descriptors,
--
Regards,
Laurent Pinchart
More information about the linux-arm-kernel
mailing list