i.MX8MM Ethernet TX Bandwidth Fluctuations
Frieder Schrempf
frieder.schrempf at kontron.de
Wed May 19 03:12:03 PDT 2021
On 19.05.21 10:40, Joakim Zhang wrote:
>
> Hi Frieder,
>
>> -----Original Message-----
>> From: Frieder Schrempf <frieder.schrempf at kontron.de>
>> Sent: 2021年5月19日 16:10
>> To: Joakim Zhang <qiangqing.zhang at nxp.com>; Dave Taht
>> <dave.taht at gmail.com>
>> Cc: dl-linux-imx <linux-imx at nxp.com>; netdev at vger.kernel.org;
>> linux-arm-kernel at lists.infradead.org
>> Subject: Re: i.MX8MM Ethernet TX Bandwidth Fluctuations
>>
>> Hi Joakim,
>>
>> On 19.05.21 09:49, Joakim Zhang wrote:
>>>
>>> Hi Frieder,
>>>
>>>> -----Original Message-----
>>>> From: Frieder Schrempf <frieder.schrempf at kontron.de>
>>>> Sent: 2021年5月18日 20:55
>>>> To: Joakim Zhang <qiangqing.zhang at nxp.com>; Dave Taht
>>>> <dave.taht at gmail.com>
>>>> Cc: dl-linux-imx <linux-imx at nxp.com>; netdev at vger.kernel.org;
>>>> linux-arm-kernel at lists.infradead.org
>>>> Subject: Re: i.MX8MM Ethernet TX Bandwidth Fluctuations
>>>>
>>>>
>>>>
>>>> On 18.05.21 14:35, Joakim Zhang wrote:
>>>>>
>>>>> Hi Dave,
>>>>>
>>>>>> -----Original Message-----
>>>>>> From: Dave Taht <dave.taht at gmail.com>
>>>>>> Sent: 2021年5月17日 20:48
>>>>>> To: Joakim Zhang <qiangqing.zhang at nxp.com>
>>>>>> Cc: Frieder Schrempf <frieder.schrempf at kontron.de>; dl-linux-imx
>>>>>> <linux-imx at nxp.com>; netdev at vger.kernel.org;
>>>>>> linux-arm-kernel at lists.infradead.org
>>>>>> Subject: Re: i.MX8MM Ethernet TX Bandwidth Fluctuations
>>>>>>
>>>>>> On Mon, May 17, 2021 at 3:25 AM Joakim Zhang
>>>>>> <qiangqing.zhang at nxp.com>
>>>>>> wrote:
>>>>>>>
>>>>>>>
>>>>>>> Hi Frieder,
>>>>>>>
>>>>>>>> -----Original Message-----
>>>>>>>> From: Frieder Schrempf <frieder.schrempf at kontron.de>
>>>>>>>> Sent: 2021年5月17日 15:17
>>>>>>>> To: Joakim Zhang <qiangqing.zhang at nxp.com>; dl-linux-imx
>>>>>>>> <linux-imx at nxp.com>; netdev at vger.kernel.org;
>>>>>>>> linux-arm-kernel at lists.infradead.org
>>>>>>>> Subject: Re: i.MX8MM Ethernet TX Bandwidth Fluctuations
>>>>>>>>
>>>>>>>> Hi Joakim,
>>>>>>>>
>>>>>>>> On 13.05.21 14:36, Joakim Zhang wrote:
>>>>>>>>>
>>>>>>>>> Hi Frieder,
>>>>>>>>>
>>>>>>>>> For NXP release kernel, I tested on i.MX8MQ/MM/MP, I can
>>>>>>>>> reproduce on
>>>>>>>> L5.10, and can't reproduce on L5.4.
>>>>>>>>> According to your description, you can reproduce this issue both
>>>>>>>>> L5.4 and
>>>>>>>> L5.10? So I need confirm with you.
>>>>>>>>
>>>>>>>> Thanks for looking into this. I could reproduce this on 5.4 and
>>>>>>>> 5.10 but both kernels were official mainline kernels and **not**
>>>>>>>> from the linux-imx downstream tree.
>>>>>>> Ok.
>>>>>>>
>>>>>>>> Maybe there is some problem in the mainline tree and it got
>>>>>>>> included in the NXP release kernel starting from L5.10?
>>>>>>> No, this much looks like a known issue, it should always exist
>>>>>>> after adding
>>>>>> AVB support in mainline.
>>>>>>>
>>>>>>> ENET IP is not a _real_ multiple queues per my understanding,
>>>>>>> queue
>>>>>>> 0 is for
>>>>>> best effort. And the queue 1&2 is for AVB stream whose default
>>>>>> bandwidth fraction is 0.5 in driver. (i.e. 50Mbps for 100Mbps and
>>>>>> 500Mbps
>>>> for 1Gbps).
>>>>>> When transmitting packets, net core will select queues randomly,
>>>>>> which caused the tx bandwidth fluctuations. So you can change to
>>>>>> use single queue if you care more about tx bandwidth. Or you can
>>>>>> refer to NXP internal implementation.
>>>>>>> e.g.
>>>>>>> --- a/arch/arm64/boot/dts/freescale/imx8mq.dtsi
>>>>>>> +++ b/arch/arm64/boot/dts/freescale/imx8mq.dtsi
>>>>>>> @@ -916,8 +916,8 @@
>>>>>>> <&clk
>>>>>> IMX8MQ_CLK_ENET_PHY_REF>;
>>>>>>> clock-names = "ipg", "ahb",
>> "ptp",
>>>>>>>
>> "enet_clk_ref",
>>>>>> "enet_out";
>>>>>>> - fsl,num-tx-queues = <3>;
>>>>>>> - fsl,num-rx-queues = <3>;
>>>>>>> + fsl,num-tx-queues = <1>;
>>>>>>> + fsl,num-rx-queues = <1>;
>>>>>>> status = "disabled";
>>>>>>> };
>>>>>>> };
>>>>>>>
>>>>>>> I hope this can help you :)
>>>>>>
>>>>>> Patching out the queues is probably not the right thing.
>>>>>>
>>>>>> for starters... Is there BQL support in this driver? It would be
>>>>>> helpful to have on all queues.
>>>>> There is no BQL support in this driver, and BQL may improve
>>>>> throughput
>>>> further, but should not be the root cause of this reported issue.
>>>>>
>>>>>> Also if there was a way to present it as two interfaces, rather
>>>>>> than one, that would allow for a specific avb device to be presented.
>>>>>>
>>>>>> Or:
>>>>>>
>>>>>> Is there a standard means of signalling down the stack via the IP
>>>>>> layer (a
>>>> dscp?
>>>>>> a setsockopt?) that the AVB queue is requested?
>>>>>>
>>>>> AFAIK, AVB is scope of VLAN, so we can queue AVB packets into queue
>>>>> 1&2
>>>> based on VLAN-ID.
>>>>
>>>> I had to look up what AVB even means, but from my current
>>>> understanding it doesn't seem right that for non-AVB packets the
>>>> driver picks any of the three queues in a random fashion while at the
>>>> same time knowing that queue 1 and 2 have a 50% limitation on the
>>>> bandwidth. Shouldn't there be some way to prefer queue 0 without
>>>> needing the user to set it up or even arbitrarily limiting the number of
>> queues as proposed above?
>>>
>>> Yes, I think we can. I look into NXP local implementation, there is a
>> ndo_select_queue callback.
>>> https://eur01.safelinks.protection.outlook.com/?url=https%3A%2F%2Fsour
>>>
>> ce.codeaurora.org%2Fexternal%2Fimx%2Flinux-imx%2Ftree%2Fdrivers%2Fnet
>> %
>>>
>> 2Fethernet%2Ffreescale%2Ffec_main.c%3Fh%3Dlf-5.4.y%23n3419&data=
>> 04
>>> %7C01%7Cqiangqing.zhang%40nxp.com%7Cd83917f3c76c4b6ef80008d91a9
>> d8a28%7
>>>
>> C686ea1d3bc2b4c6fa92cd99c5c301635%7C0%7C0%7C637570086193978287%
>> 7CUnkno
>>>
>> wn%7CTWFpbGZsb3d8eyJWIjoiMC4wLjAwMDAiLCJQIjoiV2luMzIiLCJBTiI6Ik1ha
>> WwiL
>>>
>> CJXVCI6Mn0%3D%7C1000&sdata=pQuGAadGzM8GhYsVl%2FG%2BPJSCZ
>> RRvbwhuLy9
>>> g30bn3ok%3D&reserved=0
>>> This is the version for L5.4 kernel.
>>
>> Yes, this looks like it could solve the issue. Would you mind preparing a patch to
>> upstream the change in [1]? I would be happy to test (at least the non-AVB
>> case) and review.
>
> Yes, I can have a try. I saw this patch has been staying in downstream tree for many years, and I don't know the history.
> Anyway, I will try to upstream first to see if anyone has comments.
Thanks, that would be great. Please put me on cc if you send the patch.
Just for the record:
When I set fsl,num-tx-queues = <1>, I do see that the bandwidth-drops don't occur anymore. When I instead apply the queue selection patch from the downstream kernel, I also see that queue 0 is always picked for my untagged traffic. In both cases bandwidth stays just as high as expected (> 900 Mbit/s).
More information about the linux-arm-kernel
mailing list