[PATCH v2 2/2] pinctrl: single: set pinmux from pins debug file

[Tony Lindgren]

Hi,

I noticed few more things I started to wonder about after
looking at this again.

* Dario Binacchi <dariobin at libero.it> [210517 20:00]:
> +static int pcs_pin_dbg_set(struct pinctrl_dev *pctldev, unsigned int pin,
> +			   char *buf)
> +{
> +	struct pcs_device *pcs;
> +	unsigned int val, mux_bytes;
> +
> +	buf = skip_spaces(buf);
> +	if (kstrtouint(buf, 0, &val))
> +		return -EINVAL;
> +
> +	pcs = pinctrl_dev_get_drvdata(pctldev);
> +
> +	mux_bytes = pcs->width / BITS_PER_BYTE;
> +	pcs->write(val, pcs->base + pin * mux_bytes);
> +	return 0;
> +}

Since you're adding a new interface, how about pass unsigned
int val instead of char *buf?

>  static void pcs_dt_free_map(struct pinctrl_dev *pctldev,
>  				struct pinctrl_map *map, unsigned num_maps)
>  {
> @@ -331,6 +348,9 @@ static const struct pinctrl_ops pcs_pinctrl_ops = {
>  	.get_group_name = pinctrl_generic_get_group_name,
>  	.get_group_pins = pinctrl_generic_get_group_pins,
>  	.pin_dbg_show = pcs_pin_dbg_show,
> +#if IS_ENABLED(CONFIG_DEVMEM)
> +	.pin_dbg_set = pcs_pin_dbg_set,
> +#endif
>  	.dt_node_to_map = pcs_dt_node_to_map,
>  	.dt_free_map = pcs_dt_free_map,
>  };

It might be better to always have the .pin_dbg_set around to
avoid the IS_ENABLED(CONFIG_DEVMEM).

Does the new interface need something under Documentation too?

Regards,

Tony