[PATCH 4/5] arm64: dts: ti: k3-am642-sk: Enable USB Super-Speed HOST port

Nishanth Menon nm at ti.com
Wed May 12 12:40:22 PDT 2021


On 20:31-20210512, Kishon Vijay Abraham I wrote:
> Enable USB Super-Speed HOST port.
> 
> Signed-off-by: Kishon Vijay Abraham I <kishon at ti.com>
> Signed-off-by: Aswath Govindraju <a-govindraju at ti.com>
> ---
>  arch/arm64/boot/dts/ti/k3-am642-sk.dts | 39 ++++++++++++++++++++++++++
>  1 file changed, 39 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/ti/k3-am642-sk.dts b/arch/arm64/boot/dts/ti/k3-am642-sk.dts
> index 8424cd071955..056c1b2df559 100644
> --- a/arch/arm64/boot/dts/ti/k3-am642-sk.dts
> +++ b/arch/arm64/boot/dts/ti/k3-am642-sk.dts
> @@ -5,6 +5,8 @@
>  
>  /dts-v1/;
>  
> +#include <dt-bindings/mux/ti-serdes.h>
> +#include <dt-bindings/phy/phy.h>
>  #include <dt-bindings/gpio/gpio.h>
>  #include <dt-bindings/net/ti-dp83867.h>
>  #include "k3-am642.dtsi"
> @@ -85,6 +87,12 @@
>  		>;
>  	};
>  
> +	main_usb0_pins_default: main-usb0-pins-default {
> +		pinctrl-single,pins = <
> +			AM64X_IOPAD(0x02a8, PIN_OUTPUT, 0) /* (E19) USB0_DRVVBUS */
> +		>;
> +	};
> +
>  	main_i2c1_pins_default: main-i2c1-pins-default {
>  		pinctrl-single,pins = <
>  			AM64X_IOPAD(0x0268, PIN_INPUT_PULLUP, 0) /* (C18) I2C1_SCL */
> @@ -235,6 +243,37 @@
>  	disable-wp;
>  };
>  
> +&serdes_ln_ctrl {
> +	idle-states = <AM64_SERDES0_LANE0_USB>;
> +};
> +
> +&serdes_wiz0 {
> +	status = "okay";


not sure I understand why default of okay needs to be explicitly stated
as okay in board dts.

> +};
> +
> +&serdes0 {
> +	serdes0_usb_link: phy at 0 {
> +		reg = <0>;
> +		cdns,num-lanes = <1>;
> +		#phy-cells = <0>;
> +		cdns,phy-type = <PHY_TYPE_USB3>;
> +		resets = <&serdes_wiz0 1>;
> +	};
> +};
> +
> +&usbss0 {
> +	ti,vbus-divider;
> +};
> +
> +&usb0 {
> +	dr_mode = "host";
> +	maximum-speed = "super-speed";
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&main_usb0_pins_default>;
> +	phys = <&serdes0_usb_link>;
> +	phy-names = "cdns3,usb3-phy";
> +};
> +
>  &cpsw3g {
>  	pinctrl-names = "default";
>  	pinctrl-0 = <&mdio1_pins_default
> -- 
> 2.17.1
> 

-- 
Regards,
Nishanth Menon
Key (0xDDB5849D1736249D) / Fingerprint: F8A2 8693 54EB 8232 17A3  1A34 DDB5 849D 1736 249D



More information about the linux-arm-kernel mailing list