[PATCH V3 13/13] soc: imx: gpcv2: move reset assert after requesting domain power up

[Peng Fan (OSS)]

From: Peng Fan <peng.fan at nxp.com>

The i.MX8MM VPU power up sequence is a bit special, it must follow:
1. request power up
2. reset assert
3. reset deassert

This change in this patch will not affect other domains, because
the power domain default is in asserted state, unless bootloader
deassert the reset. It also applies to GPU power domain.

Reviewed-by: Frieder Schrempf <frieder.schrempf at kontron.de>
Tested-by: Frieder Schrempf <frieder.schrempf at kontron.de>
Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
 drivers/soc/imx/gpcv2.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/soc/imx/gpcv2.c b/drivers/soc/imx/gpcv2.c
index 2490757f759d..35bbb1bc5159 100644
--- a/drivers/soc/imx/gpcv2.c
+++ b/drivers/soc/imx/gpcv2.c
@@ -217,8 +217,6 @@ static int imx_pgc_power_up(struct generic_pm_domain *genpd)
 		goto out_regulator_disable;
 	}
 
-	reset_control_assert(domain->reset);
-
 	if (domain->bits.pxx) {
 		/* request the domain to power up */
 		regmap_update_bits(domain->regmap, GPC_PU_PGC_SW_PUP_REQ,
@@ -241,6 +239,8 @@ static int imx_pgc_power_up(struct generic_pm_domain *genpd)
 				  GPC_PGC_CTRL_PCR);
 	}
 
+	reset_control_assert(domain->reset);
+
 	/* delay for reset to propagate */
 	udelay(5);
 
-- 
2.30.0