[PATCH 03/42] PCI: aardvark: Fix checking for PIO status
Pali Rohár
pali at kernel.org
Thu May 6 08:31:14 PDT 2021
From: Evan Wang <xswang at marvell.com>
There is an issue that when PCIe switch is connected to an Armada 3700
board, there will be lots of warnings about PIO errors when reading the
config space. According to Aardvark PIO read and write sequence in HW
specification, the current way to check PIO status has the following
issues:
1) For PIO read operation, it reports the error message, which should be
avoided according to HW specification.
2) For PIO read and write operations, it only checks PIO operation complete
status, which is not enough, and error status should also be checked.
This patch aligns the code with Aardvark PIO read and write sequence in HW
specification on PIO status check and fix the warnings when reading config
space.
This patch also returns Completion Retry Status value when the read request
timeout, to give the caller a chance to send the request again instead of
failing.
Signed-off-by: Evan Wang <xswang at marvell.com>
Reviewed-by: Victor Gu <xigu at marvell.com>
Tested-by: Victor Gu <xigu at marvell.com>
[pali: Return CRS also after timeout]
Signed-off-by: Pali Rohár <pali at kernel.org>
Reviewed-by: Marek Behún <kabel at kernel.org>
Cc: stable at vger.kernel.org # b1bd5714472c ("PCI: aardvark: Indicate error in 'val' when config read fails")
---
drivers/pci/controller/pci-aardvark.c | 93 +++++++++++++++++++++++----
1 file changed, 80 insertions(+), 13 deletions(-)
diff --git a/drivers/pci/controller/pci-aardvark.c b/drivers/pci/controller/pci-aardvark.c
index 2f8380a1f84f..a37ba86f1b2d 100644
--- a/drivers/pci/controller/pci-aardvark.c
+++ b/drivers/pci/controller/pci-aardvark.c
@@ -58,6 +58,7 @@
#define PIO_COMPLETION_STATUS_CRS 2
#define PIO_COMPLETION_STATUS_CA 4
#define PIO_NON_POSTED_REQ BIT(10)
+#define PIO_ERR_STATUS BIT(11)
#define PIO_ADDR_LS (PIO_BASE_ADDR + 0x8)
#define PIO_ADDR_MS (PIO_BASE_ADDR + 0xc)
#define PIO_WR_DATA (PIO_BASE_ADDR + 0x10)
@@ -176,6 +177,9 @@
#define MSI_IRQ_NUM 32
+#define CFG_RD_UR_VAL 0xffffffff
+#define CFG_RD_CRS_VAL 0xffff0001
+
struct advk_pcie {
struct platform_device *pdev;
void __iomem *base;
@@ -461,7 +465,7 @@ static void advk_pcie_setup_hw(struct advk_pcie *pcie)
advk_writel(pcie, reg, PCIE_CORE_CMD_STATUS_REG);
}
-static void advk_pcie_check_pio_status(struct advk_pcie *pcie)
+static int advk_pcie_check_pio_status(struct advk_pcie *pcie, u32 *val)
{
struct device *dev = &pcie->pdev->dev;
u32 reg;
@@ -472,15 +476,50 @@ static void advk_pcie_check_pio_status(struct advk_pcie *pcie)
status = (reg & PIO_COMPLETION_STATUS_MASK) >>
PIO_COMPLETION_STATUS_SHIFT;
- if (!status)
- return;
-
+ /*
+ * According to HW spec, the PIO status check sequence as below:
+ * 1) even if COMPLETION_STATUS(bit9:7) indicates successful,
+ * it still needs to check Error Status(bit11), only when this bit
+ * indicates no error happen, the operation is successful.
+ * 2) value Unsupported Request(1) of COMPLETION_STATUS(bit9:7) only
+ * means a PIO write error, and for PIO read it is successful with
+ * a read value of 0xFFFFFFFF.
+ * 3) value Completion Retry Status(CRS) of COMPLETION_STATUS(bit9:7)
+ * only means a PIO write error, and for PIO read it is successful
+ * with a read value of 0xFFFF0001.
+ * 4) value Completer Abort (CA) of COMPLETION_STATUS(bit9:7) means
+ * error for both PIO read and PIO write operation.
+ * 5) other errors are indicated as 'unknown'.
+ */
switch (status) {
+ case PIO_COMPLETION_STATUS_OK:
+ if (reg & PIO_ERR_STATUS) {
+ strcomp_status = "COMP_ERR";
+ break;
+ }
+ /* Get the read result */
+ if (val)
+ *val = advk_readl(pcie, PIO_RD_DATA);
+ /* No error */
+ strcomp_status = NULL;
+ break;
case PIO_COMPLETION_STATUS_UR:
- strcomp_status = "UR";
+ if (val) {
+ /* For reading, UR is not an error status */
+ *val = CFG_RD_UR_VAL;
+ strcomp_status = NULL;
+ } else {
+ strcomp_status = "UR";
+ }
break;
case PIO_COMPLETION_STATUS_CRS:
- strcomp_status = "CRS";
+ if (val) {
+ /* For reading, CRS is not an error status */
+ *val = CFG_RD_CRS_VAL;
+ strcomp_status = NULL;
+ } else {
+ strcomp_status = "CRS";
+ }
break;
case PIO_COMPLETION_STATUS_CA:
strcomp_status = "CA";
@@ -490,6 +529,9 @@ static void advk_pcie_check_pio_status(struct advk_pcie *pcie)
break;
}
+ if (!strcomp_status)
+ return 0;
+
if (reg & PIO_NON_POSTED_REQ)
str_posted = "Non-posted";
else
@@ -497,6 +539,8 @@ static void advk_pcie_check_pio_status(struct advk_pcie *pcie)
dev_err(dev, "%s PIO Response Status: %s, %#x @ %#x\n",
str_posted, strcomp_status, reg, advk_readl(pcie, PIO_ADDR_LS));
+
+ return -EFAULT;
}
static int advk_pcie_wait_pio(struct advk_pcie *pcie)
@@ -703,8 +747,17 @@ static int advk_pcie_rd_conf(struct pci_bus *bus, u32 devfn,
size, val);
if (advk_pcie_pio_is_running(pcie)) {
- *val = 0xffffffff;
- return PCIBIOS_SET_FAILED;
+ /*
+ * For PCI_VENDOR_ID register, return Completion Retry Status
+ * so caller tries to issue the request again insted of failing
+ */
+ if (where == PCI_VENDOR_ID) {
+ *val = CFG_RD_CRS_VAL;
+ return PCIBIOS_SUCCESSFUL;
+ } else {
+ *val = 0xffffffff;
+ return PCIBIOS_SET_FAILED;
+ }
}
/* Program the control register */
@@ -729,15 +782,27 @@ static int advk_pcie_rd_conf(struct pci_bus *bus, u32 devfn,
advk_writel(pcie, 1, PIO_START);
ret = advk_pcie_wait_pio(pcie);
+ if (ret < 0) {
+ /*
+ * For PCI_VENDOR_ID register, return Completion Retry Status
+ * so caller tries to issue the request again instead of failing
+ */
+ if (where == PCI_VENDOR_ID) {
+ *val = CFG_RD_CRS_VAL;
+ return PCIBIOS_SUCCESSFUL;
+ } else {
+ *val = 0xffffffff;
+ return PCIBIOS_SET_FAILED;
+ }
+ }
+
+ /* Check PIO status and get the read result */
+ ret = advk_pcie_check_pio_status(pcie, val);
if (ret < 0) {
*val = 0xffffffff;
return PCIBIOS_SET_FAILED;
}
- advk_pcie_check_pio_status(pcie);
-
- /* Get the read result */
- *val = advk_readl(pcie, PIO_RD_DATA);
if (size == 1)
*val = (*val >> (8 * (where & 3))) & 0xff;
else if (size == 2)
@@ -801,7 +866,9 @@ static int advk_pcie_wr_conf(struct pci_bus *bus, u32 devfn,
if (ret < 0)
return PCIBIOS_SET_FAILED;
- advk_pcie_check_pio_status(pcie);
+ ret = advk_pcie_check_pio_status(pcie, NULL);
+ if (ret < 0)
+ return PCIBIOS_SET_FAILED;
return PCIBIOS_SUCCESSFUL;
}
--
2.20.1
More information about the linux-arm-kernel
mailing list