[PATCH v4 1/2] dt-bindings: imx6q-pcie: add one regulator used to power up pcie phy

[Lucas Stach]

Am Montag, dem 29.03.2021 um 16:03 +0800 schrieb Richard Zhu:
> Both 1.8v and 3.3v power supplies can be used by i.MX8MQ PCIe PHY.
> In default, the PCIE_VPH voltage is suggested to be 1.8v refer to data
> sheet. When PCIE_VPH is supplied by 3.3v in the HW schematic design,
> the VREG_BYPASS bits of GPR registers should be cleared from default
> value 1b'1 to 1b'0. Thus, the internal 3v3 to 1v8 translator would be
> turned on.
> 
> Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>

Reviewed-by: Lucas Stach <l.stach at pengutronix.de>

> ---
>  Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt | 3 +++
>  1 file changed, 3 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
> index de4b2baf91e8..d8971ab99274 100644
> --- a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
> +++ b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.txt
> @@ -38,6 +38,9 @@ Optional properties:
>    The regulator will be enabled when initializing the PCIe host and
>    disabled either as part of the init process or when shutting down the
>    host.
> +- vph-supply: Should specify the regulator in charge of VPH one of the three
> +  PCIe PHY powers. This regulator can be supplied by both 1.8v and 3.3v voltage
> +  supplies.
>  
> 
> 
> 
>  Additional required properties for imx6sx-pcie:
>  - clock names: Must include the following additional entries: