[PATCH v3 2/3] arm64: dts: imx8mq-evk: add one regulator used to power up pcie phy

[Lucas Stach]

Am Donnerstag, dem 25.03.2021 um 16:44 +0800 schrieb Richard Zhu:
> Both 1.8v and 3.3v power supplies can be used by i.MX8MQ PCIe PHY.
> In default, the PCIE_VPH voltage is suggested to be 1.8v refer to data
> sheet. When PCIE_VPH is supplied by 3.3v in the HW schematic design,
> the VREG_BYPASS bits of GPR registers should be cleared from default
> value 1b'1 to 1b'0. Thus, the internal 3v3 to 1v8 translator would be
> turned on.
> 
> Signed-off-by: Richard Zhu <hongxing.zhu at nxp.com>

Reviewed-by: Lucas Stach <l.stach at pengutronix.de>

I guess you need to split this patch out of the series and post it for
Shawn to pick up into the imx DT tree, after the other two patches of
the series have been accepted into the PCIe tree.

Regards,
Lucas

> ---
>  arch/arm64/boot/dts/freescale/imx8mq-evk.dts | 1 +
>  1 file changed, 1 insertion(+)
> 
> diff --git a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> index 85b045253a0e..4d2035e3dd7c 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> +++ b/arch/arm64/boot/dts/freescale/imx8mq-evk.dts
> @@ -318,6 +318,7 @@
>  		 <&clk IMX8MQ_CLK_PCIE1_PHY>,
>  		 <&pcie0_refclk>;
>  	clock-names = "pcie", "pcie_aux", "pcie_phy", "pcie_bus";
> +	vph-supply = <&vgen5_reg>;
>  	status = "okay";
>  };
>  
> 
> 
>