[PATCH v5 1/3] arm64: dts: ti: k3-j7200: Add gpio nodes

[Grygorii Strashko]

On 10/03/2021 18:19, Aswath Govindraju wrote:
> From: Faiz Abbas <faiz_abbas at ti.com>
> 
> There are 4 instances of gpio modules in main domain:
> 	gpio0, gpio2, gpio4 and gpio6
> 
> Groups are created to provide protection between different processor
> virtual worlds. Each of these modules I/O pins are muxed within the
> group. Exactly one module can be selected to control the corresponding
> pin by selecting it in the pad mux configuration registers.
> 
> This group in main domain pins out 69 lines (5 banks). Add DT modes for
> each module instance in the main domain.
> 
> Similar to the gpio groups in main domain, there is one gpio group in
> wakeup domain with 2 module instances in it.
> 
> The gpio group pins out 72 pins (6 banks) of the first 85 gpio lines. Add
> DT nodes for each module instance in the wakeup domain.
> 
> Signed-off-by: Faiz Abbas <faiz_abbas at ti.com>
> Signed-off-by: Sekhar Nori <nsekhar at ti.com>
> Signed-off-by: Aswath Govindraju <a-govindraju at ti.com>
> ---
>   arch/arm64/boot/dts/ti/k3-j7200-main.dtsi     | 72 +++++++++++++++++++
>   .../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi      | 34 +++++++++
>   2 files changed, 106 insertions(+)
> 
Reviewed-by: Grygorii Strashko <grygorii.strashko at ti.com>

-- 
Best regards,
grygorii