[PATCH v5 00/18] arm64: dts: imx8: architecture improvement and adding imx8qm support

[Aisheng Dong]

> From: Shawn Guo <shawnguo at kernel.org>
> Sent: Monday, March 8, 2021 10:00 AM
> 
> On Fri, Mar 05, 2021 at 09:17:29PM +0800, Dong Aisheng wrote:
> > IMX SCU based platforms (e.g. MX8QM/MX8QXP) are comprised of a
> number
> > of SS (Subsystems), those SS may be shared between different SoCs
> > while most of them can be reused like Devices Resources, Clocks, Power
> domains and etc.
> >
> > This patch series aims to improve the MX8 architecture to comply with
> > the HW design to save a lot of duplicated codes and benefits us a
> > better maintainability and scalability in the future.
> >
> > ChangeLog:
> > v5:
> >  * rebase to latest shawn/for-next
> >  * make mx8qm usdhc compatible with imx8qxp
> > v4-resend:
> >  * no change except put three module binding patches first which are used
> >    by this patchset.
> > v3->v4:
> >  * mainly rebase to latest kernel except a few very minor changes like
> change to use
> >    new scu protocol binding which was not supported in last version
> > v2->v3:
> >  * use clock-indices property instead of bit-offset property suggested
> > by Shawn Guo
> >  * rebase to latest shawn/for-next
> > v1->v2:
> >  * change to the new two cells scu clock binding, so original adding scu
> clocks
> >    patches were removed.
> >  * Move scu pd node above clk node
> >
> >
> > Dong Aisheng (18):
> >   dt-bindings: arm: fsl: add imx8qm boards compatible string
> >   dt-bindings: mailbox: mu: add imx8qm support
> >   arm64: dts: imx8qxp: add fallback compatible string for scu pd
> >   arm64: dts: imx8qxp: move scu pd node before scu clock node
> >   arm64: dts: imx8qxp: orginize dts in subsystems
> 
> The dts patches stop applying for me at this one.  Please rebase and resend
> them.

It was caused by below patch you just applied.

commit f5a069ca4f420872861035ef304e75108bb5ec6e
Author: Peng Fan <peng.fan at nxp.com>
Date:   Thu Feb 25 11:10:02 2021 +0800

    arm64: dts: imx8qxp: correct usdhc clock-names sequence
    
    Per dt-bindings, the clock-names sequence should be ipg ahb per to pass
    dtbs_check.
    
    Signed-off-by: Peng Fan <peng.fan at nxp.com>
    Signed-off-by: Shawn Guo <shawnguo at kernel.org>

 arch/arm64/boot/dts/freescale/imx8qxp.dtsi | 18 +++++++++---------
 1 file changed, 9 insertions(+), 9 deletions(-)

I will rebase and resend. Thanks

Regards
Aisheng

> 
> Shawn
> 
> >   arm64: dts: imx8: add lsio lpcg clocks
> >   arm64: dts: imx8: add conn lpcg clocks
> >   arm64: dts: imx8: add adma lpcg clocks
> >   arm64: dts: imx8: switch to two cell scu clock binding
> >   arm64: dts: imx8: switch to new lpcg clock binding
> >   arm64: dts: imx8qm: add lsio ss support
> >   arm64: dts: imx8qm: add conn ss support
> >   arm64: dts: imx8: split adma ss into dma and audio ss
> >   arm64: dts: imx8qm: add dma ss support
> >   arm64: dts: imx: add imx8qm common dts file
> >   arm64: dts: imx: add imx8qm mek support
> >   arm64: defconfig: add imx8qm mek support
> >   firmware: imx: scu-pd: do not power off console domain
> >
> >  .../devicetree/bindings/arm/fsl.yaml          |   6 +
> >  .../devicetree/bindings/mailbox/fsl,mu.yaml   |   5 +-
> >  arch/arm64/boot/dts/freescale/Makefile        |   1 +
> >  .../boot/dts/freescale/imx8-ss-adma.dtsi      |   8 +
> >  .../boot/dts/freescale/imx8-ss-audio.dtsi     |  68 +++
> >  .../boot/dts/freescale/imx8-ss-conn.dtsi      | 184 ++++++++
> >  .../arm64/boot/dts/freescale/imx8-ss-ddr.dtsi |  18 +
> > .../arm64/boot/dts/freescale/imx8-ss-dma.dtsi | 202 +++++++++
> >  .../boot/dts/freescale/imx8-ss-lsio.dtsi      | 311 +++++++++++++
> >  arch/arm64/boot/dts/freescale/imx8qm-mek.dts  | 144 ++++++
> >  .../boot/dts/freescale/imx8qm-ss-conn.dtsi    |  21 +
> >  .../boot/dts/freescale/imx8qm-ss-dma.dtsi     |  51 +++
> >  .../boot/dts/freescale/imx8qm-ss-lsio.dtsi    |  61 +++
> >  arch/arm64/boot/dts/freescale/imx8qm.dtsi     | 176 ++++++++
> >  .../boot/dts/freescale/imx8qxp-ai_ml.dts      |  20 +-
> >  .../freescale/imx8qxp-colibri-eval-v3.dtsi    |   8 +-
> >  .../boot/dts/freescale/imx8qxp-colibri.dtsi   |  12 +-
> >  arch/arm64/boot/dts/freescale/imx8qxp-mek.dts |  50 +--
> >  .../boot/dts/freescale/imx8qxp-ss-adma.dtsi   |  37 ++
> >  .../boot/dts/freescale/imx8qxp-ss-conn.dtsi   |  25 ++
> >  .../boot/dts/freescale/imx8qxp-ss-lsio.dtsi   |  61 +++
> >  arch/arm64/boot/dts/freescale/imx8qxp.dtsi    | 423 ++----------------
> >  arch/arm64/configs/defconfig                  |   1 +
> >  drivers/firmware/imx/scu-pd.c                 |  28 +-
> >  24 files changed, 1481 insertions(+), 440 deletions(-)  create mode
> > 100644 arch/arm64/boot/dts/freescale/imx8-ss-adma.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8-ss-audio.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8-ss-conn.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8-ss-ddr.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8-ss-dma.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8-ss-lsio.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8qm-mek.dts
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8qm-ss-conn.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8qm-ss-dma.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8qm-ss-lsio.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8qm.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8qxp-ss-adma.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8qxp-ss-conn.dtsi
> >  create mode 100644 arch/arm64/boot/dts/freescale/imx8qxp-ss-lsio.dtsi
> >
> > --
> > 2.25.1
> >