[PATCH 04/17] usb: xhci-mtk: add only one extra CS for FS/LS INTR

[Chunfeng Yun]

In USB2 Spec:
"11.18.5 TT Response Generation
In general, there will be two (or more) complete-split
transactions scheduled for a periodic endpoint.
However, for interrupt endpoints, the maximum size of
the full-/low-speed transaction guarantees that it can
never require more than two complete-split transactions.
Two complete-split transactions are only required
when the transaction spans a microframe boundary."

Due to the maxp is 64, and less then 188 (at most in one
microframe), seems never span boundary, so use only one CS
for FS/LS interrupt transfer, this will save some bandwidth.

Signed-off-by: Chunfeng Yun <chunfeng.yun at mediatek.com>
---
 drivers/usb/host/xhci-mtk-sch.c | 10 +++-------
 1 file changed, 3 insertions(+), 7 deletions(-)

diff --git a/drivers/usb/host/xhci-mtk-sch.c b/drivers/usb/host/xhci-mtk-sch.c
index e3b18dfca874..817ef2815e67 100644
--- a/drivers/usb/host/xhci-mtk-sch.c
+++ b/drivers/usb/host/xhci-mtk-sch.c
@@ -408,13 +408,11 @@ static int check_sch_tt(struct usb_device *udev,
 {
 	struct mu3h_sch_tt *tt = sch_ep->sch_tt;
 	u32 extra_cs_count;
-	u32 fs_budget_start;
 	u32 start_ss, last_ss;
 	u32 start_cs, last_cs;
 	int i;
 
 	start_ss = offset % 8;
-	fs_budget_start = (start_ss + 1) % 8;
 
 	if (sch_ep->ep_type == ISOC_OUT_EP) {
 		last_ss = start_ss + sch_ep->cs_count - 1;
@@ -450,16 +448,14 @@ static int check_sch_tt(struct usb_device *udev,
 		if (sch_ep->ep_type == ISOC_IN_EP)
 			extra_cs_count = (last_cs == 7) ? 1 : 2;
 		else /*  ep_type : INTR IN / INTR OUT */
-			extra_cs_count = (fs_budget_start == 6) ? 1 : 2;
+			extra_cs_count = 1;
 
 		cs_count += extra_cs_count;
 		if (cs_count > 7)
 			cs_count = 7; /* HW limit */
 
-		for (i = 0; i < cs_count + 2; i++) {
-			if (test_bit(offset + i, tt->ss_bit_map))
-				return -ERANGE;
-		}
+		if (test_bit(offset, tt->ss_bit_map))
+			return -ERANGE;
 
 		sch_ep->cs_count = cs_count;
 		/* one for ss, the other for idle */
-- 
2.18.0