[PATCH 2/4] iio: adc: at91-sama5d2: initialize hardware after clock is started

[Eugen Hristev]

The hw_init hardware init call must happen after the clock is prepared and
enabled. Otherwise, writing to the registers might lead to a block or
external abort.

Signed-off-by: Eugen Hristev <eugen.hristev at microchip.com>
---
 drivers/iio/adc/at91-sama5d2_adc.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/iio/adc/at91-sama5d2_adc.c b/drivers/iio/adc/at91-sama5d2_adc.c
index a7826f097b95..63325f037f09 100644
--- a/drivers/iio/adc/at91-sama5d2_adc.c
+++ b/drivers/iio/adc/at91-sama5d2_adc.c
@@ -1832,12 +1832,12 @@ static int at91_adc_probe(struct platform_device *pdev)
 		goto vref_disable;
 	}
 
-	at91_adc_hw_init(indio_dev);
-
 	ret = clk_prepare_enable(st->per_clk);
 	if (ret)
 		goto vref_disable;
 
+	at91_adc_hw_init(indio_dev);
+
 	platform_set_drvdata(pdev, indio_dev);
 
 	ret = at91_adc_buffer_and_trigger_init(&pdev->dev, indio_dev);
-- 
2.25.1