[PATCH 2/2] arm64: dts: ti: k3-am642-evm: Add USB support

[Aswath Govindraju]

AM64 EVM board has a micro USB 2.0 AB connector and the USB0_VBUS is
connected with a resistor divider in between. USB0_DRVVBUS pin is muxed
between USB0_DRVVBUS and GPIO1_79 signals.

Add the corresponding properties and set the pinmux mode for USB subsystem
in the evm dts file.

Signed-off-by: Aswath Govindraju <a-govindraju at ti.com>
Acked-by: Roger Quadros <rogerq at ti.com>
---
 arch/arm64/boot/dts/ti/k3-am642-evm.dts | 18 ++++++++++++++++++
 1 file changed, 18 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-am642-evm.dts b/arch/arm64/boot/dts/ti/k3-am642-evm.dts
index 1f1787750fef..bfd849a29655 100644
--- a/arch/arm64/boot/dts/ti/k3-am642-evm.dts
+++ b/arch/arm64/boot/dts/ti/k3-am642-evm.dts
@@ -133,6 +133,12 @@
 			AM64X_IOPAD(0x026c, PIN_INPUT_PULLUP, 0) /* (B19) I2C1_SDA */
 		>;
 	};
+
+	main_usb0_pins_default: main-usb0-pins-default {
+		pinctrl-single,pins = <
+			AM64X_IOPAD(0x02a8, PIN_OUTPUT, 0) /* (E19) USB0_DRVVBUS */
+		>;
+	};
 };
 
 &main_uart0 {
@@ -227,6 +233,18 @@
 	status = "disabled";
 };
 
+&usbss0 {
+	ti,vbus-divider;
+	ti,usb2-only;
+};
+
+&usb0 {
+	dr_mode = "otg";
+	maximum-speed = "high-speed";
+	pinctrl-names = "default";
+	pinctrl-0 = <&main_usb0_pins_default>;
+};
+
 &sdhci0 {
 	/* emmc */
 	bus-width = <8>;
-- 
2.17.1