[RFC-PATCH] net: stmmac: Add KR port support.

[Andrew Lunn]

On Fri, Jul 30, 2021 at 07:48:30AM -0700, Daniel Walker wrote:
> On Fri, Jul 30, 2021 at 05:01:44AM +0200, Andrew Lunn wrote:
> > On Thu, Jul 29, 2021 at 04:44:42PM -0700, Daniel Walker wrote:
> > > From: Balamurugan Selvarajan <balamsel at cisco.com>
> > > 
> > > For KR port the mii interface is a chip-to-chip
> > > interface without a mechanical connector. So PHY
> > > inits are not applicable. In this case MAC is
> > > configured to operate at forced speed(1000Mbps)
> > > and full duplex. Modified driver to accommodate
> > > PHY and NON-PHY mode.
> > 
> > I agree with Florian here. Look at all the in kernel examples of a SoC
> > MAC connected to an Ethernet switch. Some use rgmii, others 1000BaseX
> > or higher. But they all follow the same scheme, and don't need
> > invasive MAC driver changes.
> 
> 
> Can you provide the examples which you looked at ?

There are plenty of examples using Freescale FEC and Marvell Ethernet
switches:

arch/arm/boot/dts/vf610-zii-dev-rev-b.dts

Or the Mavell based

arch/arm/boot/dts/armada-xp-linksys-mamba.dts

	Andrew