[PATCH 3/5] ARM: dts: Add basic support for EcoNet EN7523

[Mark Rutland]

On Fri, Jul 30, 2021 at 03:45:50PM +0200, Bert Vermeulen wrote:
> From: John Crispin <john at phrozen.org>
> 
> Add basic support for EcoNet EN7523, enough for booting to console.
> 
> The UART is basically 8250-compatible, except for the clock selection.
> A clock-frequency value is synthesized to get this to run at 115200 bps.
> 
> Signed-off-by: John Crispin <john at phrozen.org>
> Signed-off-by: Bert Vermeulen <bert at biot.com>
> ---
>  arch/arm/boot/dts/Makefile       |   2 +
>  arch/arm/boot/dts/en7523-evb.dts |  17 ++++
>  arch/arm/boot/dts/en7523.dtsi    | 128 +++++++++++++++++++++++++++++++
>  3 files changed, 147 insertions(+)
>  create mode 100644 arch/arm/boot/dts/en7523-evb.dts
>  create mode 100644 arch/arm/boot/dts/en7523.dtsi
> 

> +	cpus {
> +		#address-cells = <1>;
> +		#size-cells = <0>;

> +		cpu0: cpu at 0 {
> +			device_type = "cpu";
> +			compatible = "arm,cortex-a7";
> +			reg = <0x0>;
> +			enable-method = "psci";
> +			clock-frequency = <80000000>;
> +			next-level-cache = <&L2_0>;
> +
> +		};

> +	gic: interrupt-controller at 09000000 {
> +		compatible = "arm,gic-v3";
> +		interrupt-controller;
> +		#interrupt-cells = <3>;
> +		#address-cells = <1>;
> +		#size-cells = <1>;
> +		reg = <0x09000000 0x20000>,
> +			  <0x09080000 0x80000>;
> +		interrupts = <GIC_PPI 9 IRQ_TYPE_LEVEL_LOW>;
> +
> +		its: gic-its at 09020000 {
> +			compatible = "arm,gic-v3-its";
> +			msi-controller;
> +			#msi-cell = <1>;

Missing 's' here for '#msi-cells'.

> +			reg = <0x090200000 0x20000>;
> +		};
> +	};

Looking at this again, I was under the impression that Cortex-A7 only
supported GICv2; is this actually a Cortex-A7 or a different CPU?

Which revision is this?

Thanks,
Mark.