[PATCH 3/5] ARM: dts: Add basic support for EcoNet EN7523
Linus Walleij
linus.walleij at linaro.org
Fri Jul 30 07:31:36 PDT 2021
Paging Marc Z and Catalin just so they can see this:
On Fri, Jul 30, 2021 at 3:49 PM Bert Vermeulen <bert at biot.com> wrote:
> From: John Crispin <john at phrozen.org>
>
> Add basic support for EcoNet EN7523, enough for booting to console.
>
> The UART is basically 8250-compatible, except for the clock selection.
> A clock-frequency value is synthesized to get this to run at 115200 bps.
>
> Signed-off-by: John Crispin <john at phrozen.org>
> Signed-off-by: Bert Vermeulen <bert at biot.com>
(...)
> + gic: interrupt-controller at 09000000 {
> + compatible = "arm,gic-v3";
> + interrupt-controller;
> + #interrupt-cells = <3>;
> + #address-cells = <1>;
> + #size-cells = <1>;
> + reg = <0x09000000 0x20000>,
> + <0x09080000 0x80000>;
> + interrupts = <GIC_PPI 9 IRQ_TYPE_LEVEL_LOW>;
> +
> + its: gic-its at 09020000 {
> + compatible = "arm,gic-v3-its";
> + msi-controller;
> + #msi-cell = <1>;
> + reg = <0x090200000 0x20000>;
> + };
> + };
Yup GICv3 on ARM32-only silicon.
> + timer {
> + compatible = "arm,armv8-timer";
> + interrupt-parent = <&gic>;
> + interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
> + <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
> + <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
> + <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>;
> + clock-frequency = <25000000>;
> + };
Also arm,armv8-timer on ARM32-only silicon.
This is kind of a first.
Yours,
Linus Walleij
More information about the linux-arm-kernel
mailing list