[PATCH 4/9] arm64: dts: rockchip: add rk356x gmac1 node
Heiko Stübner
heiko at sntech.de
Wed Jul 28 07:21:15 PDT 2021
Hi Peter,
Am Mittwoch, 28. Juli 2021, 15:55:29 CEST schrieb Peter Geis:
> Add the gmac1 controller to the rk356x device tree.
> This is the controller common to both the rk3568 and rk3566.
>
> Signed-off-by: Peter Geis <pgwipeout at gmail.com>
> ---
> arch/arm64/boot/dts/rockchip/rk356x.dtsi | 48 ++++++++++++++++++++++++
> 1 file changed, 48 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/rockchip/rk356x.dtsi b/arch/arm64/boot/dts/rockchip/rk356x.dtsi
> index c2aa7aeec58d..77c679304916 100644
> --- a/arch/arm64/boot/dts/rockchip/rk356x.dtsi
> +++ b/arch/arm64/boot/dts/rockchip/rk356x.dtsi
> @@ -18,6 +18,7 @@ / {
> #size-cells = <2>;
>
> aliases {
> + ethernet1 = &gmac1;
> gpio0 = &gpio0;
> gpio1 = &gpio1;
> gpio2 = &gpio2;
Looking back at the discussion about mmc aliases in board-dts vs. soc-dtsi
I get the feeling the ethernet alias would be same case, as not all boards
will expose ethernet.
In the very least the ethernet alias should be part of the rk3566/rk3568 dtsi
files, doing ethernet0 = &gmac1 for rk3566 and ethernet1 = &gmac1 for rk3568.
But I do think the board-dts would be the more appropriate place.
Heiko
> @@ -344,6 +345,53 @@ sdmmc2: mmc at fe000000 {
> status = "disabled";
> };
>
> + gmac1: ethernet at fe010000 {
> + compatible = "rockchip,rk3568-gmac", "snps,dwmac-4.20a";
> + reg = <0x0 0xfe010000 0x0 0x10000>;
> + interrupts = <GIC_SPI 32 IRQ_TYPE_LEVEL_HIGH>,
> + <GIC_SPI 29 IRQ_TYPE_LEVEL_HIGH>;
> + interrupt-names = "macirq", "eth_wake_irq";
> + clocks = <&cru SCLK_GMAC1>, <&cru SCLK_GMAC1_RX_TX>,
> + <&cru SCLK_GMAC1_RX_TX>, <&cru CLK_MAC1_REFOUT>,
> + <&cru ACLK_GMAC1>, <&cru PCLK_GMAC1>,
> + <&cru SCLK_GMAC1_RX_TX>, <&cru CLK_GMAC1_PTP_REF>;
> + clock-names = "stmmaceth", "mac_clk_rx",
> + "mac_clk_tx", "clk_mac_refout",
> + "aclk_mac", "pclk_mac",
> + "clk_mac_speed", "ptp_ref";
> + resets = <&cru SRST_A_GMAC1>;
> + reset-names = "stmmaceth";
> + rockchip,grf = <&grf>;
> + snps,mixed-burst;
> + snps,tso;
> + snps,axi-config = <&gmac1_stmmac_axi_setup>;
> + snps,mtl-rx-config = <&gmac1_mtl_rx_setup>;
> + snps,mtl-tx-config = <&gmac1_mtl_tx_setup>;
> + status = "disabled";
> +
> + mdio1: mdio {
> + compatible = "snps,dwmac-mdio";
> + #address-cells = <0x1>;
> + #size-cells = <0x0>;
> + };
> +
> + gmac1_stmmac_axi_setup: stmmac-axi-config {
> + snps,wr_osr_lmt = <4>;
> + snps,rd_osr_lmt = <8>;
> + snps,blen = <0 0 0 0 16 8 4>;
> + };
> +
> + gmac1_mtl_rx_setup: rx-queues-config {
> + snps,rx-queues-to-use = <1>;
> + queue0 {};
> + };
> +
> + gmac1_mtl_tx_setup: tx-queues-config {
> + snps,tx-queues-to-use = <1>;
> + queue0 {};
> + };
> + };
> +
> qos_gpu: qos at fe128000 {
> compatible = "rockchip,rk3568-qos", "syscon";
> reg = <0x0 0xfe128000 0x0 0x20>;
>
More information about the linux-arm-kernel
mailing list