[PATCH v2 3/4] arm64: dts: ti: k3-am642-evm: Add pwm nodes

[Grygorii Strashko]

On 21/07/2021 14:36, Lokesh Vutla wrote:
> ecap0 can be configured to use pad ECAP0_IN_APWM_OUT (D18) which has a
> signal connected to Pin 1 of J12 on EVM. Add support for adding this
> pinmux so that pwm can be observed on pin 1 of Header J12
> 
> Also mark all un-used epwm and ecap pwm nodes as disabled.
> 
> Signed-off-by: Lokesh Vutla <lokeshvutla at ti.com>
> ---
>   arch/arm64/boot/dts/ti/k3-am642-evm.dts | 56 +++++++++++++++++++++++++
>   1 file changed, 56 insertions(+)
> 

Reviewed-by: Grygorii Strashko <grygorii.strashko at ti.com>

-- 
Best regards,
grygorii