[PATCH 4/4] ARM: dts: imx7d-sdb: Fix the SPI chipselect polarity

[Fabio Estevam]

The following warning is seen when the SPI GPIO driver probes:

gpio-expander at 0 enforce active low on chipselect handle

The reason for this warning is clearly explained in the comments inside
drivers/gpio/gpiolib-of.c:
    
* SPI children have active low chip selects
* by default. This can be specified negatively
* by just omitting "spi-cs-high" in the
* device node, or actively by tagging on
* GPIO_ACTIVE_LOW as flag in the device
* tree. If the line is simultaneously
* tagged as active low in the device tree
* and has the "spi-cs-high" set, we get a
* conflict and the "spi-cs-high" flag will
* take precedence.
    
To properly represent the SPI chipselect polarity, change it to active-low
when the "spi-cs-high" property is absent.

Signed-off-by: Fabio Estevam <festevam at gmail.com>
---
 arch/arm/boot/dts/imx7d-sdb.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/imx7d-sdb.dts b/arch/arm/boot/dts/imx7d-sdb.dts
index 4a0d83784d7d..7813ef960f6e 100644
--- a/arch/arm/boot/dts/imx7d-sdb.dts
+++ b/arch/arm/boot/dts/imx7d-sdb.dts
@@ -45,7 +45,7 @@ spi4 {
 		pinctrl-0 = <&pinctrl_spi4>;
 		gpio-sck = <&gpio1 13 GPIO_ACTIVE_HIGH>;
 		gpio-mosi = <&gpio1 9 GPIO_ACTIVE_HIGH>;
-		cs-gpios = <&gpio1 12 GPIO_ACTIVE_HIGH>;
+		cs-gpios = <&gpio1 12 GPIO_ACTIVE_LOW>;
 		num-chipselects = <1>;
 		#address-cells = <1>;
 		#size-cells = <0>;
-- 
2.25.1