[PATCH v2] KVM: arm64: Disabling disabled PMU counters wastes a lot of time

[Alexandre Chartre]

On 7/12/21 5:51 PM, Alexandru Elisei wrote:
> Hi Robin,
> 
> On 7/12/21 4:44 PM, Robin Murphy wrote:
>> On 2021-07-12 16:17, Alexandre Chartre wrote:
>>> In a KVM guest on arm64, performance counters interrupts have an
>>> unnecessary overhead which slows down execution when using the "perf
>>> record" command and limits the "perf record" sampling period.
>>>
>>> The problem is that when a guest VM disables counters by clearing the
>>> PMCR_EL0.E bit (bit 0), KVM will disable all counters defined in
>>> PMCR_EL0 even if they are not enabled in PMCNTENSET_EL0.
>>>
>>> KVM disables a counter by calling into the perf framework, in particular
>>> by calling perf_event_create_kernel_counter() which is a time consuming
>>> operation. So, for example, with a Neoverse N1 CPU core which has 6 event
>>> counters and one cycle counter, KVM will always disable all 7 counters
>>> even if only one is enabled.
>>>
>>> This typically happens when using the "perf record" command in a guest
>>> VM: perf will disable all event counters with PMCNTENTSET_EL0 and only
>>> uses the cycle counter. And when using the "perf record" -F option with
>>> a high profiling frequency, the overhead of KVM disabling all counters
>>> instead of one on every counter interrupt becomes very noticeable.
>>>
>>> The problem is fixed by having KVM disable only counters which are
>>> enabled in PMCNTENSET_EL0. If a counter is not enabled in PMCNTENSET_EL0
>>> then KVM will not enable it when setting PMCR_EL0.E and it will remain
>>> disabled as long as it is not enabled in PMCNTENSET_EL0. So there is
>>> effectively no need to disable a counter when clearing PMCR_EL0.E if it
>>> is not enabled PMCNTENSET_EL0.
>>>
>>> Signed-off-by: Alexandre Chartre <alexandre.chartre at oracle.com>
>>> ---
>>> The patch is based on
>>> https://git.kernel.org/pub/scm/linux/kernel/git/maz/arm-platforms.git/log/?h=kvm-arm64/pmu/reset-values
>>>
>>>    arch/arm64/kvm/pmu-emul.c | 8 +++++---
>>>    1 file changed, 5 insertions(+), 3 deletions(-)
>>>
>>> diff --git a/arch/arm64/kvm/pmu-emul.c b/arch/arm64/kvm/pmu-emul.c
>>> index fae4e95b586c..1f317c3dac61 100644
>>> --- a/arch/arm64/kvm/pmu-emul.c
>>> +++ b/arch/arm64/kvm/pmu-emul.c
>>> @@ -563,21 +563,23 @@ void kvm_pmu_software_increment(struct kvm_vcpu *vcpu,
>>> u64 val)
>>>     */
>>>    void kvm_pmu_handle_pmcr(struct kvm_vcpu *vcpu, u64 val)
>>>    {
>>> -    unsigned long mask = kvm_pmu_valid_counter_mask(vcpu);
>>> +    unsigned long mask;
>>>        int i;
>>>          if (val & ARMV8_PMU_PMCR_E) {
>>>            kvm_pmu_enable_counter_mask(vcpu,
>>>                   __vcpu_sys_reg(vcpu, PMCNTENSET_EL0));
>>>        } else {
>>> -        kvm_pmu_disable_counter_mask(vcpu, mask);
>>> +        kvm_pmu_disable_counter_mask(vcpu,
>>> +               __vcpu_sys_reg(vcpu, PMCNTENSET_EL0));
>>>        }
>>>          if (val & ARMV8_PMU_PMCR_C)
>>>            kvm_pmu_set_counter_value(vcpu, ARMV8_PMU_CYCLE_IDX, 0);
>>>          if (val & ARMV8_PMU_PMCR_P) {
>>> -        mask &= ~BIT(ARMV8_PMU_CYCLE_IDX);
>>> +        mask = kvm_pmu_valid_counter_mask(vcpu)
>>> +            & BIT(ARMV8_PMU_CYCLE_IDX);
>>
>> This looks suspiciously opposite of what it replaces;
> 
> It always sets the bit, which goes against the architecture and the code it was
> replacing, yes.
> 

My bad, I screw up and I dropped the ~. I will resend.

Sorry,

alex.

>> however did we even need to do a bitwise operation here in the first place?
>> Couldn't we skip the cycle counter by just limiting the for_each_set_bit
>> iteration below to 31 bits?
> 
> To quote myself [1]:
> 
> "Entertained the idea of restricting the number of bits in for_each_set_bit() to
> 31 since Linux (and the architecture, to some degree) treats the cycle count
> register as the 32nd event counter. Settled on this approach because I think it's
> clearer."
> 
> To expand on that, incorrectly resetting the cycle counter was introduced by a
> refactoring, so I preferred making it very clear that PMCR_EL0.P is not supposed
> to clear the cycle counter.
> 
> [1] https://lore.kernel.org/kvmarm/20210618105139.83795-1-alexandru.elisei@arm.com/
> 
> Thanks,
> 
> Alex
> 
>>
>> Robin.
>>
>>>            for_each_set_bit(i, &mask, 32)
>>>                kvm_pmu_set_counter_value(vcpu, i, 0);
>>>        }
>>>
>>> base-commit: 83f870a663592797c576846db3611e0a1664eda2
>>>