[PATCH v2] arm64: dts: ti: k3-j7200-main: Add support for higher speed modes in MMCSD subsystems

[Aswath Govindraju]

Hi,

On 25/01/21 9:55 pm, Aswath Govindraju wrote:
> The following speed modes are now supported in J7200 SoC,
> - HS200 and HS400 modes at 1.8 V card voltage, in MMCSD0 subsystem [1].
> - UHS-I speed modes in MMCSD1 subsystem [1].
> 
> Set respective tags in sdhci0 and remove no-1-8-v tag from sdhci1 device
> tree nodes.
> 
> [1] - section 12.3.6.1.1 MMCSD Features, in
>       https://www.ti.com/lit/ug/spruiu1a/spruiu1a.pdf
> 
> Signed-off-by: Aswath Govindraju <a-govindraju at ti.com>
> ---
> 
> performance test logs using EXT4 filesystem for eMMC HS400 speed mode,
> https://pastebin.ubuntu.com/p/JnPs8DxV58/
> 
> performance test logs using EXT4 filesystem for SD SDR104 speed mode,
> https://pastebin.ubuntu.com/p/KPGzBz8YwC/
> 
> Changes since v1:
> - Squashed the two patches into one
> - added performance logs for the above mentioned speed modes
> 
>  arch/arm64/boot/dts/ti/k3-j7200-main.dtsi | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/ti/k3-j7200-main.dtsi b/arch/arm64/boot/dts/ti/k3-j7200-main.dtsi
> index 4cc2e9094d0e..4b3d0b5739e8 100644
> --- a/arch/arm64/boot/dts/ti/k3-j7200-main.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-j7200-main.dtsi
> @@ -517,6 +517,8 @@
>  		ti,trm-icp = <0x8>;
>  		bus-width = <8>;
>  		mmc-ddr-1_8v;
> +		mmc-hs200-1_8v;
> +		mmc-hs400-1_8v;
>  		dma-coherent;
>  	};
>  
> @@ -534,7 +536,6 @@
>  		ti,otap-del-sel-sdr50 = <0xc>;
>  		ti,otap-del-sel-sdr104 = <0x5>;
>  		ti,otap-del-sel-ddr50 = <0xc>;
> -		no-1-8-v;
>  		dma-coherent;
>  	};
>  
> 

Please ignore this patch. Sorry, I forgot to add voltage regulator nodes
required to enable UHS modes. While testing there was an error from my
side.

Thanks,
Aswath