[PATCH 04/10] ARM: dts: imx6: RDU2: only trigger IRQ on falling edge ucs1002 ALERT pin

[Lucas Stach]

The ALERT signaling happens on the falling edge of the signal, as rising
edge doesn't really have any notion, as it may happen much later (due to
shared IRQ line) or too early if the chip resolves the fault itself. So
only trigger the IRQ on the edge we are actually interested in.

Signed-off-by: Lucas Stach <l.stach at pengutronix.de>
---
 arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
index ba26e1b8c474..dcc97a84c88d 100644
--- a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
@@ -628,7 +628,7 @@
 		pinctrl-0 = <&pinctrl_ucs1002_pins>;
 		reg = <0x32>;
 		interrupts-extended = <&gpio5 2 IRQ_TYPE_EDGE_BOTH>,
-				      <&gpio3 21 IRQ_TYPE_EDGE_BOTH>;
+		                      <&gpio3 21 IRQ_TYPE_EDGE_FALLING>;
 		interrupt-names = "a_det", "alert";
 	};
 
-- 
2.20.1