[PATCH 1/2] thermal: remove tango driver

[Måns Rullgård]

Arnd Bergmann <arnd at kernel.org> writes:

> From: Arnd Bergmann <arnd at arndb.de>
>
> The tango platform is getting removed, so the driver is no
> longer needed.
>
> Cc: Marc Gonzalez <marc.w.gonzalez at free.fr>
> Cc: Mans Rullgard <mans at mansr.com>
> Signed-off-by: Arnd Bergmann <arnd at arndb.de>

Acked-by: Mans Rullgard <mans at mansr.com>

> ---
>  .../bindings/thermal/tango-thermal.txt        |  17 ---
>  drivers/thermal/Kconfig                       |   9 --
>  drivers/thermal/Makefile                      |   1 -
>  drivers/thermal/tango_thermal.c               | 126 ------------------
>  4 files changed, 153 deletions(-)
>  delete mode 100644 Documentation/devicetree/bindings/thermal/tango-thermal.txt
>  delete mode 100644 drivers/thermal/tango_thermal.c
>
> diff --git a/Documentation/devicetree/bindings/thermal/tango-thermal.txt b/Documentation/devicetree/bindings/thermal/tango-thermal.txt
> deleted file mode 100644
> index 2c918d742867..000000000000
> --- a/Documentation/devicetree/bindings/thermal/tango-thermal.txt
> +++ /dev/null
> @@ -1,17 +0,0 @@
> -* Tango Thermal
> -
> -The SMP8758 SoC includes 3 instances of this temperature sensor
> -(in the CPU, video decoder, and PCIe controller).
> -
> -Required properties:
> -- #thermal-sensor-cells: Should be 0 (see Documentation/devicetree/bindings/thermal/thermal-sensor.yaml)
>
> -- compatible: "sigma,smp8758-thermal"
> -- reg: Address range of the thermal registers
> -
> -Example:
> -
> -	cpu_temp: thermal at 920100 {
> -		#thermal-sensor-cells = <0>;
> -		compatible = "sigma,smp8758-thermal";
> -		reg = <0x920100 12>;
> -	};
>
> diff --git a/drivers/thermal/Kconfig b/drivers/thermal/Kconfig
> index 7edc8dc6bbab..cf199574c096 100644
> --- a/drivers/thermal/Kconfig
> +++ b/drivers/thermal/Kconfig
> @@ -450,15 +450,6 @@ depends on (ARCH_STI || ARCH_STM32) && OF
>  source "drivers/thermal/st/Kconfig"
>  endmenu
>
> -config TANGO_THERMAL
> -	tristate "Tango thermal management"
> -	depends on ARCH_TANGO || COMPILE_TEST
> -	help
> -	  Enable the Tango thermal driver, which supports the primitive
> -	  temperature sensor embedded in Tango chips since the SMP8758.
> -	  This sensor only generates a 1-bit signal to indicate whether
> -	  the die temperature exceeds a programmable threshold.
> -
>  source "drivers/thermal/tegra/Kconfig"
>
>  config GENERIC_ADC_THERMAL
> diff --git a/drivers/thermal/Makefile b/drivers/thermal/Makefile
> index b64dd50a6629..a44dda2d03bc 100644
> --- a/drivers/thermal/Makefile
> +++ b/drivers/thermal/Makefile
> @@ -42,7 +42,6 @@ obj-y				+= samsung/
>  obj-$(CONFIG_DOVE_THERMAL)  	+= dove_thermal.o
>  obj-$(CONFIG_DB8500_THERMAL)	+= db8500_thermal.o
>  obj-$(CONFIG_ARMADA_THERMAL)	+= armada_thermal.o
> -obj-$(CONFIG_TANGO_THERMAL)	+= tango_thermal.o
>  obj-$(CONFIG_IMX_THERMAL)	+= imx_thermal.o
>  obj-$(CONFIG_IMX_SC_THERMAL)	+= imx_sc_thermal.o
>  obj-$(CONFIG_IMX8MM_THERMAL)	+= imx8mm_thermal.o
> diff --git a/drivers/thermal/tango_thermal.c b/drivers/thermal/tango_thermal.c
> deleted file mode 100644
> index 304b461e12aa..000000000000
> --- a/drivers/thermal/tango_thermal.c
> +++ /dev/null
> @@ -1,126 +0,0 @@
> -// SPDX-License-Identifier: GPL-2.0-only
> -#include <linux/io.h>
> -#include <linux/delay.h>
> -#include <linux/module.h>
> -#include <linux/thermal.h>
> -#include <linux/platform_device.h>
> -
> -/*
> - * According to a data sheet draft, "this temperature sensor uses a bandgap
> - * type of circuit to compare a voltage which has a negative temperature
> - * coefficient with a voltage that is proportional to absolute temperature.
> - * A resistor bank allows 41 different temperature thresholds to be selected
> - * and the logic output will then indicate whether the actual die temperature
> - * lies above or below the selected threshold."
> - */
> -
> -#define TEMPSI_CMD	0
> -#define TEMPSI_RES	4
> -#define TEMPSI_CFG	8
> -
> -#define CMD_OFF		0
> -#define CMD_ON		1
> -#define CMD_READ	2
> -
> -#define IDX_MIN		15
> -#define IDX_MAX		40
> -
> -struct tango_thermal_priv {
> -	void __iomem *base;
> -	int thresh_idx;
> -};
> -
> -static bool temp_above_thresh(void __iomem *base, int thresh_idx)
> -{
> -	writel(CMD_READ | thresh_idx << 8, base + TEMPSI_CMD);
> -	usleep_range(10, 20);
> -	writel(CMD_READ | thresh_idx << 8, base + TEMPSI_CMD);
> -
> -	return readl(base + TEMPSI_RES);
> -}
> -
> -static int tango_get_temp(void *arg, int *res)
> -{
> -	struct tango_thermal_priv *priv = arg;
> -	int idx = priv->thresh_idx;
> -
> -	if (temp_above_thresh(priv->base, idx)) {
> -		/* Search upward by incrementing thresh_idx */
> -		while (idx < IDX_MAX && temp_above_thresh(priv->base, ++idx))
> -			cpu_relax();
> -		idx = idx - 1; /* always return lower bound */
> -	} else {
> -		/* Search downward by decrementing thresh_idx */
> -		while (idx > IDX_MIN && !temp_above_thresh(priv->base, --idx))
> -			cpu_relax();
> -	}
> -
> -	*res = (idx * 9 / 2 - 38) * 1000; /* millidegrees Celsius */
> -	priv->thresh_idx = idx;
> -
> -	return 0;
> -}
> -
> -static const struct thermal_zone_of_device_ops ops = {
> -	.get_temp	= tango_get_temp,
> -};
> -
> -static void tango_thermal_init(struct tango_thermal_priv *priv)
> -{
> -	writel(0, priv->base + TEMPSI_CFG);
> -	writel(CMD_ON, priv->base + TEMPSI_CMD);
> -}
> -
> -static int tango_thermal_probe(struct platform_device *pdev)
> -{
> -	struct resource *res;
> -	struct tango_thermal_priv *priv;
> -	struct thermal_zone_device *tzdev;
> -
> -	priv = devm_kzalloc(&pdev->dev, sizeof(*priv), GFP_KERNEL);
> -	if (!priv)
> -		return -ENOMEM;
> -
> -	res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> -	priv->base = devm_ioremap_resource(&pdev->dev, res);
> -	if (IS_ERR(priv->base))
> -		return PTR_ERR(priv->base);
> -
> -	platform_set_drvdata(pdev, priv);
> -	priv->thresh_idx = IDX_MIN;
> -	tango_thermal_init(priv);
> -
> -	tzdev = devm_thermal_zone_of_sensor_register(&pdev->dev, 0, priv, &ops);
> -	return PTR_ERR_OR_ZERO(tzdev);
> -}
> -
> -static int __maybe_unused tango_thermal_resume(struct device *dev)
> -{
> -	tango_thermal_init(dev_get_drvdata(dev));
> -	return 0;
> -}
> -
> -static SIMPLE_DEV_PM_OPS(tango_thermal_pm, NULL, tango_thermal_resume);
> -
> -static const struct of_device_id tango_sensor_ids[] = {
> -	{
> -		.compatible = "sigma,smp8758-thermal",
> -	},
> -	{ /* sentinel */ }
> -};
> -MODULE_DEVICE_TABLE(of, tango_sensor_ids);
> -
> -static struct platform_driver tango_thermal_driver = {
> -	.probe	= tango_thermal_probe,
> -	.driver	= {
> -		.name		= "tango-thermal",
> -		.of_match_table	= tango_sensor_ids,
> -		.pm		= &tango_thermal_pm,
> -	},
> -};
> -
> -module_platform_driver(tango_thermal_driver);
> -
> -MODULE_LICENSE("GPL");
> -MODULE_AUTHOR("Sigma Designs");
> -MODULE_DESCRIPTION("Tango temperature sensor");
> -- 
>
> 2.29.2
>

-- 
Måns Rullgård