[PATCH 04/12] arm64: dts: zynqmp: Enable and wire reset controller

[Michal Simek]

Hi,

On 12/7/20 10:32 AM, Michal Simek wrote:
> 
> 
> On 06. 12. 20 23:38, Laurent Pinchart wrote:
>> Hi Michal,
>>
>> Thank you for the patch.
>>
>> On Wed, Dec 02, 2020 at 03:06:03PM +0100, Michal Simek wrote:
>>> Enable reset controller for several IPs.
>>>
>>> Signed-off-by: Michal Simek <michal.simek at xilinx.com>
>>> ---
>>>
>>>  arch/arm64/boot/dts/xilinx/zynqmp.dtsi | 29 ++++++++++++++++++++++++++
>>>  1 file changed, 29 insertions(+)
>>>
>>> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp.dtsi b/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
>>> index 68923fbd0e89..4fa820f78d76 100644
>>> --- a/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
>>> +++ b/arch/arm64/boot/dts/xilinx/zynqmp.dtsi
>>> @@ -187,6 +187,11 @@ zynqmp_pcap: pcap {
>>>  			xlnx_aes: zynqmp-aes {
>>>  				compatible = "xlnx,zynqmp-aes";
>>>  			};
>>> +
>>> +			zynqmp_reset: reset-controller {
>>> +				compatible = "xlnx,zynqmp-reset";
>>> +				#reset-cells = <1>;
>>> +			};
>>>  		};
>>>  	};
>>>  
>>> @@ -466,6 +471,8 @@ gem0: ethernet at ff0b0000 {
>>>  			#address-cells = <1>;
>>>  			#size-cells = <0>;
>>>  			power-domains = <&zynqmp_firmware PD_ETH_0>;
>>> +			resets = <&zynqmp_reset ZYNQMP_RESET_GEM0>;
>>> +			reset-names = "gem0_rst";
>>
>> I don't see any of the reset-names used in this patch defined in DT
>> bindings (or used in drivers). For all devices but the USB controllers
>> it seems they can be dropped. For the USB controllers, the bindings need
>> to be updated first.
> 
> Let me double check it. IIRC if there is just one there is likely no
> need to list the name but if there are more then one names should be
> also there. But you are right it should be the part of dt binding.

I will skip this patch.

Thanks,
Michal