[PATCH v2 2/8] arm64: dts: allwinner: H6: properly connect USB PHY to port 0

[Andre Przywara]

In recent Allwinner SoCs the first USB host controller (HCI0) shares
the first PHY with the MUSB controller. Probably to make this sharing
work, we were avoiding to declare this in the DT. This has two
shortcomings:
- U-Boot (which uses the same .dts) cannot use this port in host mode
  without a PHY linked, so we were loosing one USB port there.
- It requires the MUSB driver to be enabled and loaded, although we
  don't actually use it.

To avoid those issues, let's add this PHY link to the H6 .dtsi file.
After all PHY port 0 *is* connected to HCI0, so we should describe
it as this.

This makes it work in U-Boot, also improves compatiblity when no MUSB
driver is loaded (for instance in distribution installers).

Fixes: eabb3d424b6d ("arm64: dts: allwinner: h6: add USB2-related device nodes")
Signed-off-by: Andre Przywara <andre.przywara at arm.com>
---
 arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
index 8a62a9fbe347..f593cfeaecc9 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
@@ -680,6 +680,8 @@
 				 <&ccu CLK_USB_OHCI0>;
 			resets = <&ccu RST_BUS_OHCI0>,
 				 <&ccu RST_BUS_EHCI0>;
+			phys = <&usb2phy 0>;
+			phy-names = "usb";
 			status = "disabled";
 		};
 
@@ -690,6 +692,8 @@
 			clocks = <&ccu CLK_BUS_OHCI0>,
 				 <&ccu CLK_USB_OHCI0>;
 			resets = <&ccu RST_BUS_OHCI0>;
+			phys = <&usb2phy 0>;
+			phy-names = "usb";
 			status = "disabled";
 		};
 
-- 
2.17.5