BUG about Hisilicon PMU

[Shaokun Zhang]

Hi Zhengyuan,

Thanks for your quick reply,

在 2021/1/11 19:38, Zhengyuan Liu 写道:
> On Mon, Jan 11, 2021 at 5:34 PM Shaokun Zhang
> <zhangshaokun at hisilicon.com> wrote:
>>
>> Hi John/Zhengyuan,
>>
>> 在 2021/1/11 17:13, John Garry 写道:
>>> On 11/01/2021 08:25, Zhengyuan Liu wrote:
>>>> Hi, all
>>>>
>>>> When boot v5.11-rc2 on my Kunpeng 920 PC, the kernel will block at PMU
>>>> initialization stage, and after binary-search with bisect I found that
>>>> this problem was introduced by commit ac4511c9364c ("drivers/perf:
>>>> hisi: Add identifier sysfs file"),
>>>> and to be more accurate it actually blocked at following position:
>>>>
>>>>      hisi_hha_pmu_init_data():
>>>>           hha_pmu->identifier = readl(hha_pmu->base + HHA_VERSION);
>>>>
>>>> If you guys had already know this problem, please ignore this message.
>>>
>>> Do you have a dmesg? I don't see anything to block here, only crash.
>>> Does v5.11-rc1 boot ok?
>>>
> 
> V5.11-rc1 has included this patch, therefore also bad.
> 
> The dmesg does not have any error message, It only blocked which seems
> the cpu doesn't work,
> and I can hear the rotation rate of fans increasing rapidly.
> 
> I also built the PMU from Y to M, it has the same phenomenon when the
> module is loaded.
> 
>>> It works fine on my D06CS (which includes Kunpeng 920) with rc3:
>>>
>>> john at debian:~$ more /sys/bus/event_source/devices/hisi_sccl5_hha7/identifier
>>> 0x00000000
>>> john at debian:~$ uname -a
>>> Linux debian 5.11.0-rc3-dirty #139 SMP PREEMPT Mon Jan 11 08:42:26 GMT 2021 aarch64 GNU/Linux
>>> john at debian:~$
>>>
>>> @Shaokun, Do you know what could be the problem on PC?
>>
>> I doubt the UEFI which maybe give more HHA numbers than PC has or give the wrong
>> mmap address space that may cause this issue.
>> So please can you tell more information about the UEFI?
> 
> Did you mean DSDT or Bios Information?
> 

I have checked that there are some wrong PMU nodes enumerating in the UEFI
file and are you happy to get the new UEFI file from Xinwei and test it again?
Apologies for this mistake.

Thanks,
Shaokun

>>
>> Shaokun,
>>
>>>
>>> Thanks,
>>> John
>>> .
> .
>