[PATCH v2 2/3] arm64: dts: ti: k3-j7200-som-p0: Add mailboxes to R5Fs

[Suman Anna]

Add the required 'mboxes' property to all the R5F processors for the
TI J7200 common processor board. The mailboxes and some shared memory
are required for running the Remote Processor Messaging (RPMsg) stack
between the host processor and each of the R5Fs. The nodes are therefore
added in the common k3-j7200-som-p0.dtsi file so that all of these can
be co-located.

The chosen sub-mailboxes match the values used in the current firmware
images. This can be changed, if needed, as per the system integration
needs after making appropriate changes on the firmware side as well.

Note that any R5F Core1 resources are needed and used only when that
R5F cluster is configured for Split-mode.

Signed-off-by: Suman Anna <s-anna at ti.com>
---
v2: No changes

 arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi | 18 +++++++++++++++++-
 1 file changed, 17 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi b/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
index 7b5e9aa0324e..3a82982902c8 100644
--- a/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
@@ -1,6 +1,6 @@
 // SPDX-License-Identifier: GPL-2.0
 /*
- * Copyright (C) 2020 Texas Instruments Incorporated - https://www.ti.com/
+ * Copyright (C) 2020-2021 Texas Instruments Incorporated - https://www.ti.com/
  */
 
 /dts-v1/;
@@ -141,6 +141,22 @@ &mailbox0_cluster11 {
 	status = "disabled";
 };
 
+&mcu_r5fss0_core0 {
+	mboxes = <&mailbox0_cluster0 &mbox_mcu_r5fss0_core0>;
+};
+
+&mcu_r5fss0_core1 {
+	mboxes = <&mailbox0_cluster0 &mbox_mcu_r5fss0_core1>;
+};
+
+&main_r5fss0_core0 {
+	mboxes = <&mailbox0_cluster1 &mbox_main_r5fss0_core0>;
+};
+
+&main_r5fss0_core1 {
+	mboxes = <&mailbox0_cluster1 &mbox_main_r5fss0_core1>;
+};
+
 &main_i2c0 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&main_i2c0_pins_default>;
-- 
2.29.2