[PATCH 3/4] ARM: dts: imx6ul-14x14-evk: Describe the KSZ8081 reset

[Fabio Estevam]

There are two KSZ8081 on the imx6ul-14x14-evk: one has the reset line
controlled by the Q1 output of the 74LV595PW expander, and the other
by the Q2 output.

The KSZ8081 datasheet states that the tsr parameter (Stable supply
voltage (VDDIO, VDDA_3.3) to reset high) to be 10ms minimum and
"After the de-assertion of reset, wait a minimum of 100 µs before
starting programming on the MIIM (MDC/MDIO) interface." 

Describe these parameters in the devicetree.

Signed-off-by: Fabio Estevam <festevam at gmail.com>
---
 arch/arm/boot/dts/imx6ul-14x14-evk.dtsi | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/arch/arm/boot/dts/imx6ul-14x14-evk.dtsi b/arch/arm/boot/dts/imx6ul-14x14-evk.dtsi
index 8bf845afd166..ac2ec96f54e7 100644
--- a/arch/arm/boot/dts/imx6ul-14x14-evk.dtsi
+++ b/arch/arm/boot/dts/imx6ul-14x14-evk.dtsi
@@ -175,6 +175,10 @@
 			micrel,led-mode = <1>;
 			clocks = <&clks IMX6UL_CLK_ENET_REF>;
 			clock-names = "rmii-ref";
+			reset-gpios = <&gpio_spi 1 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <10000>;
+			reset-deassert-us = <100>;
+
 		};
 
 		ethphy1: ethernet-phy at 1 {
@@ -183,6 +187,9 @@
 			micrel,led-mode = <1>;
 			clocks = <&clks IMX6UL_CLK_ENET2_REF>;
 			clock-names = "rmii-ref";
+			reset-gpios = <&gpio_spi 2 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <10000>;
+			reset-deassert-us = <100>;
 		};
 	};
 };
-- 
2.17.1