[PATCH v2 6/8] serial: stm32: update conflicting RTS/CTS config comment

[Erwan Le Ray]

The comment for conflicting RTS/CTS config refers to "st, hw-flow-ctrl",
but this property is deprecated since the generic RTS/CTS property has
been introduced by the patch 'serial: stm32: Use generic DT binding for
announcing RTS/CTS lines'.
Update the comment to refer to both generic and deprecated RTS/CTS
properties.

Signed-off-by: Erwan Le Ray <erwan.leray at foss.st.com>

diff --git a/drivers/tty/serial/stm32-usart.c b/drivers/tty/serial/stm32-usart.c
index 938d2c4aeaed..0d6c7f3375f0 100644
--- a/drivers/tty/serial/stm32-usart.c
+++ b/drivers/tty/serial/stm32-usart.c
@@ -1031,7 +1031,10 @@ static int stm32_usart_init_port(struct stm32_port *stm32port,
 		goto err_clk;
 	}
 
-	/* Both CTS/RTS gpios and "st,hw-flow-ctrl" should not be specified */
+	/*
+	 * Both CTS/RTS gpios and "st,hw-flow-ctrl" (deprecated) or "uart-has-rtscts"
+	 * properties should not be specified.
+	 */
 	if (stm32port->hw_flow_control) {
 		if (mctrl_gpio_to_gpiod(stm32port->gpios, UART_GPIO_CTS) ||
 		    mctrl_gpio_to_gpiod(stm32port->gpios, UART_GPIO_RTS)) {
-- 
2.17.1