[PATCH v4 2/2] arm64: dts: imx8mm: Add Gateworks i.MX 8M Mini Development Kits
Tim Harvey
tharvey at gateworks.com
Mon Jan 4 11:14:20 EST 2021
On Mon, Jan 4, 2021 at 4:36 AM Krzysztof Kozlowski <krzk at kernel.org> wrote:
>
> On Wed, Dec 30, 2020 at 09:58:43AM -0800, Tim Harvey wrote:
> > The Gateworks Venice GW71xx-0x/GW72xx-0x/GW73xx-0x are development
> > kits comprised of a GW700x SoM and a Baseboard. Future SoM's such
> > as the GW701x will create additional combinations.
> >
> > The GW700x SoM contains:
> > - i.MX 8M Mini SoC
> > - LPDDR4 DRAM
> > - eMMC FLASH
> > - Gateworks System Controller (eeprom/pushbutton/reset/voltage-monitor)
> > - GbE PHY connected to the i.MX 8M Mini FEC
> > - Power Management IC
> >
> > The GW71xx Baseboard contains:
> > - 1x MiniPCIe Socket with USB2.0, PCIe, and SIM
> > - 1x RJ45 GbE (i.MX 8M Mini FEC)
> > - I/O connector with 1x-SPI/1x-I2C/1x-UART/4x-GPIO signals
> > - PCIe Clock generator
> > - GPS and accelerometer
> > - 1x USB 2.0 Front Panel connector
> > - wide range power supply
> >
> > The GW72xx Baseboard contains:
> > - 2x MiniPCIe Socket with USB2.0, PCIe, and SIM
> > - 2x RJ45 GbE (i.MX 8M Mini FEC and LAN743x)
> > - 1x MicroSD connector
> > - 1x USB 2.0 Front Panel connector
> > - 1x SPI connector
> > - 1x Serial connector supporting 2x-UART or 1x-UART configured as 1 of:
> > RS232 w/ flow-controll, RS485, RS422
> > - PCIe Clock generator
> > - GPS and accelerometer
> > - Media Expansion connector (MIPI-CSI/MIPI-DSI/GPIO/I2S)
> > - I/O connector with 2x-ADC,2x-GPIO,1x-UART,1x-I2C
> > - wide range power supply
> >
> > The GW73xx Baseboard contains:
> > - 3x MiniPCIe Socket with USB2.0, PCIe, and SIM
> > - 2x RJ45 GbE (i.MX 8M Mini FEC and LAN743x)
> > - 1x MicroSD connector
> > - 1x USB 2.0 Front Panel connector
> > - 1x SPI connector
> > - 1x Serial connector supporting 2x-UART or 1x-UART configured as 1 of:
> > RS232 w/ flow-controll, RS485, RS422
> > - WiFi/BT
> > - PCIe Clock generator
> > - GPS and accelerometer
> > - Media Expansion connector (MIPI-CSI/MIPI-DSI/GPIO/I2S)
> > - I/O connector with 2x-ADC,2x-GPIO,1x-UART,1x-I2C
> > - wide range power supply
> >
> > Signed-off-by: Tim Harvey <tharvey at gateworks.com>
> > ---
> > v4:
> > - replace underscore with hyphen for gpio-keys node
> > - add 'off-board header' comments to i2c/spi/uart nodes that go off-board
> > - move node comments to own line above node
> > - add spaces after comma
> > - move uart2_gpio rs485 config pinmux to hoggroup as they don't necessarily
> > relate to uart2
> > - fix fifo-depth dt property for phy
> >
> > v3:
> > - fix gpio controller node name
> > - add rtc node to SoM
> > - add pmic pinctrl to SoM
> > - fixed compatible string for SoM eeprom's
> >
> > v2:
> > - fix i.MX 8M Mini name in commit log
> > - consistent use of underscore vs hyphen in labels
> > - fix gsc interrupt type
> > - fix iomux group node names
> > - fix led-controller bindings:
> > (use correct node names, color, function and remove label)
> > - use accelerometer node name vs accel
> > - remove sai3 from gw71xx baseboard
> > - added serial connector description to commit message
> > - added I/O connector description to commit message
> > - removed unnecessary #address-cells/#size-cells from gpio-keys node
> >
> > Signed-off-by: Tim Harvey <tharvey at gateworks.com>
> > ---
> > arch/arm64/boot/dts/freescale/Makefile | 3 +
> > .../boot/dts/freescale/imx8mm-venice-gw700x.dtsi | 497 +++++++++++++++++++++
> > .../boot/dts/freescale/imx8mm-venice-gw71xx-0x.dts | 19 +
> > .../boot/dts/freescale/imx8mm-venice-gw71xx.dtsi | 186 ++++++++
> > .../boot/dts/freescale/imx8mm-venice-gw72xx-0x.dts | 20 +
> > .../boot/dts/freescale/imx8mm-venice-gw72xx.dtsi | 314 +++++++++++++
> > .../boot/dts/freescale/imx8mm-venice-gw73xx-0x.dts | 19 +
> > .../boot/dts/freescale/imx8mm-venice-gw73xx.dtsi | 366 +++++++++++++++
> > 8 files changed, 1424 insertions(+)
> > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-venice-gw700x.dtsi
> > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-venice-gw71xx-0x.dts
> > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-venice-gw71xx.dtsi
> > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-venice-gw72xx-0x.dts
> > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-venice-gw72xx.dtsi
> > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-venice-gw73xx-0x.dts
> > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-venice-gw73xx.dtsi
> >
> > diff --git a/arch/arm64/boot/dts/freescale/Makefile b/arch/arm64/boot/dts/freescale/Makefile
> > index f8d5943..ecdd233 100644
> > --- a/arch/arm64/boot/dts/freescale/Makefile
> > +++ b/arch/arm64/boot/dts/freescale/Makefile
> > @@ -32,6 +32,9 @@ dtb-$(CONFIG_ARCH_MXC) += imx8mm-beacon-kit.dtb
> > dtb-$(CONFIG_ARCH_MXC) += imx8mm-evk.dtb
> > dtb-$(CONFIG_ARCH_MXC) += imx8mm-ddr4-evk.dtb
> > dtb-$(CONFIG_ARCH_MXC) += imx8mm-var-som-symphony.dtb
> > +dtb-$(CONFIG_ARCH_MXC) += imx8mm-venice-gw71xx-0x.dtb
> > +dtb-$(CONFIG_ARCH_MXC) += imx8mm-venice-gw72xx-0x.dtb
> > +dtb-$(CONFIG_ARCH_MXC) += imx8mm-venice-gw73xx-0x.dtb
> > dtb-$(CONFIG_ARCH_MXC) += imx8mn-evk.dtb
> > dtb-$(CONFIG_ARCH_MXC) += imx8mn-ddr4-evk.dtb
> > dtb-$(CONFIG_ARCH_MXC) += imx8mn-var-som-symphony.dtb
> > diff --git a/arch/arm64/boot/dts/freescale/imx8mm-venice-gw700x.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-venice-gw700x.dtsi
> > new file mode 100644
> > index 00000000..5985a39
> > --- /dev/null
> > +++ b/arch/arm64/boot/dts/freescale/imx8mm-venice-gw700x.dtsi
> > @@ -0,0 +1,497 @@
> > +// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
> > +/*
> > + * Copyright 2020 Gateworks Corporation
> > + */
> > +
> > +#include <dt-bindings/gpio/gpio.h>
> > +#include <dt-bindings/input/linux-event-codes.h>
> > +#include <dt-bindings/net/ti-dp83867.h>
> > +
> > +/ {
> > + memory at 40000000 {
> > + device_type = "memory";
> > + reg = <0x0 0x40000000 0 0x80000000>;
> > + };
> > +
> > + gpio-keys {
> > + compatible = "gpio-keys";
> > +
> > + user_pb {
>
> All these nodes as well - hyphens instead of underscore.
will fix
>
>
> > + label = "user_pb";
> > + gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
> > + linux,code = <BTN_0>;
> > + };
> > +
> > + user_pb1x {
> > + label = "user_pb1x";
> > + linux,code = <BTN_1>;
> > + interrupt-parent = <&gsc>;
> > + interrupts = <0>;
> > + };
> > +
> > + key_erased {
> > + label = "key_erased";
> > + linux,code = <BTN_2>;
> > + interrupt-parent = <&gsc>;
> > + interrupts = <1>;
> > + };
> > +
> > + eeprom_wp {
> > + label = "eeprom_wp";
> > + linux,code = <BTN_3>;
> > + interrupt-parent = <&gsc>;
> > + interrupts = <2>;
> > + };
> > +
> > + tamper {
> > + label = "tamper";
> > + linux,code = <BTN_4>;
> > + interrupt-parent = <&gsc>;
> > + interrupts = <5>;
> > + };
> > +
> > + switch_hold {
> > + label = "switch_hold";
> > + linux,code = <BTN_5>;
> > + interrupt-parent = <&gsc>;
> > + interrupts = <7>;
> > + };
> > + };
>
> Rest of DTS looks ok, thanks!
>
Great - thank you so much for the reviews! I will follow-up shortly
with another revision.
Best regards and Happy New Year!
Tim
More information about the linux-arm-kernel
mailing list