[PATCH] pinctrl: PINCTRL_MICROCHIP_SGPIO should depend on ARCH_SPARX5 || SOC_VCOREIII

[Geert Uytterhoeven]

Hi Lars,

On Wed, Feb 10, 2021 at 3:24 PM Lars Povlsen <lars.povlsen at microchip.com> wrote:
> Geert Uytterhoeven writes:
> > On Wed, Feb 10, 2021 at 3:17 PM Alexandre Belloni
> > <alexandre.belloni at bootlin.com> wrote:
> >> On 10/02/2021 14:53:01+0100, Geert Uytterhoeven wrote:
> >> > On Wed, Feb 10, 2021 at 2:45 PM Lars Povlsen <lars.povlsen at microchip.com> wrote:
> >> > > Geert Uytterhoeven writes:
> >> > > > the Microsemi/Microchip Serial GPIO device is present only Microsemi
> >> > > > VCore III and Microchip Sparx5 SoCs.  Hence add a dependency on
> >> > > > ARCH_SPARX5 || SOC_VCOREIII, to prevent asking the user about this
> >> > > > driver when configuring a kernel without support for these SoCs.
> >> > > >
> >> > > > Fixes: 7e5ea974e61c8dd0 ("pinctrl: pinctrl-microchip-sgpio: Add pinctrl driver for Microsemi Serial GPIO")
> >> > > > Signed-off-by: Geert Uytterhoeven <geert+renesas at glider.be>
> >> > > > ---
> >> > > >  drivers/pinctrl/Kconfig | 4 ++--
> >> > > >  1 file changed, 2 insertions(+), 2 deletions(-)
> >> > > >
> >> > > > diff --git a/drivers/pinctrl/Kconfig b/drivers/pinctrl/Kconfig
> >> > > > index 113073d5f89bbf70..3b75b1d7d3d1f1b0 100644
> >> > > > --- a/drivers/pinctrl/Kconfig
> >> > > > +++ b/drivers/pinctrl/Kconfig
> >> > > > @@ -353,8 +353,8 @@ config PINCTRL_OCELOT
> >> > > >
> >> > > >  config PINCTRL_MICROCHIP_SGPIO
> >> > > >         bool "Pinctrl driver for Microsemi/Microchip Serial GPIO"
> >> > > > -       depends on OF
> >> > > > -       depends on HAS_IOMEM
> >> > > > +       depends on OF && HAS_IOMEM
> >> > > > +       depends on ARCH_SPARX5 || SOC_VCOREIII || COMPILE_TEST
> >> > > >         select GPIOLIB
> >> > > >         select GPIOLIB_IRQCHIP
> >> > > >         select GENERIC_PINCONF
> >> > >
> >> > > Thank you for your patch. Unfortunately, it makes it impossible to use
> >> > > the driver across PCIe - which is a specifically desired configuration.
> >> > >
> >> > > Could you add CONFIG_PCI to the || chain?
> >> >
> >> > Sure.
> >> >
> >> > Is PCIe the only other transport over which the register can be accessed?
> >> > Or can this also be done over e.g. SPI, like on Ocelot[1]?
> >> >
> >> > [1] https://lore.kernel.org/linux-gpio/20200511145329.GV34497@piout.net/
> >> >
> >>
> >> Yes, this driver IP is also available on Ocelot (this is SOC_VCOREIII)
> >> so this is also available over SPI.
> >
> > Hence would you consider
> >
> >     depends on ARCH_SPARX5 || SOC_VCOREIII || PCI || SPI || COMPILE_TEST
> >
> > acceptable?  Or would that be futile, as must systems have PCI and/or
> > SPI enabled anyway?
> >
> > Gr{oetje,eeting}s,
> >
> >                         Geert
>
> Yes, that would be fine, but as you say - not have a lot of impact.
>
> Up to you...

OK, I'll drop this.

Gr{oetje,eeting}s,

                        Geert

-- 
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert at linux-m68k.org

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
                                -- Linus Torvalds