[PATCH v3 0/5] sunxi: fix H6 HDMI related issues

[Maxime Ripard]

On Tue, Feb 09, 2021 at 06:58:55PM +0100, Jernej Skrabec wrote:
> Over the year I got plenty of reports of troubles with H6 HDMI signal.
> Sometimes monitor flickers, sometimes there was no image at all and
> sometimes it didn't play well with AVR.
> 
> It turns out there are multiple issues. Patch 1 fixes clock issue,
> which didn't adjust parent rate, even if it is allowed to do so. Patch 2
> adds polarity config in tcon1. This is seemingly not needed for pre-HDMI2
> controllers, although BSP drivers set it accordingly every time. It
> turns out that HDMI2 controllers often don't work with monitors if
> polarity is not set correctly. Patch 3 always set clock rate for HDMI
> controller. Patch 4 fixes H6 HDMI PHY settings. Patch 5 fixes comment and
> clock rate limit (wrong reasoning).
> 
> Please take a look.
> 
> Best regards,
> Jernej
> 
> Changes from v2:
> - use clk_hw_can_set_rate_parent() directly instead of checking flags
> Changes from v1:
> - collected Chen-Yu tags (except on replaced patch 4)
> - Added some comments in patch 2
> - Replaced patch 4 (see commit log for explanation)

Applied patches 2-5, thanks
Maxime
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 228 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20210210/01947035/attachment.sig>