[PATCH 01/16] dt-bindings: net: dwmac: Add DW GMAC GPIOs properties

[Rob Herring]

On Mon, Feb 08, 2021 at 05:08:05PM +0300, Serge Semin wrote:
> Synopsys DesignWare Ethernet controllers can be synthesized with
> General-Purpose IOs support. GPIOs can work either as inputs or as outputs
> thus belong to the gpi_i and gpo_o ports respectively. The ports width
> (number of possible inputs/outputs) and the configuration registers layout
> depend on the IP-core version. For instance, DW GMAC can have from 0 to 4
> GPIs and from 0 to 4 GPOs, while DW xGMAC have a wider ports width up to
> 16 pins of each one.
> 
> So the DW MAC DT-node can be equipped with "ngpios" property, which can't
> have a value greater than 32, standard GPIO-related properties like
> "gpio-controller" and "#gpio-cells", and, if GPIs are supposed to be
> detected, IRQ-controller related properties.
> 
> Signed-off-by: Serge Semin <Sergey.Semin at baikalelectronics.ru>
> ---
>  .../devicetree/bindings/net/snps,dwmac.yaml     | 17 +++++++++++++++++
>  1 file changed, 17 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/net/snps,dwmac.yaml b/Documentation/devicetree/bindings/net/snps,dwmac.yaml
> index bdc437b14878..fcca23d3727e 100644
> --- a/Documentation/devicetree/bindings/net/snps,dwmac.yaml
> +++ b/Documentation/devicetree/bindings/net/snps,dwmac.yaml
> @@ -110,6 +110,23 @@ properties:
>    reset-names:
>      const: stmmaceth
>  
> +  ngpios:
> +    description:
> +      Total number of GPIOs the MAC supports. The property shall include both
> +      the GPI and GPO ports width.
> +    minimum: 1
> +    maximum: 32

Does the driver actually need this? I'd omit it if just to validate 
consumers are in range.

Are GPI and GPO counts independent? If so, this isn't really sufficient.

Rob