[net-next PATCH v5 01/15] Documentation: ACPI: DSD: Document MDIO PHY

[Calvin Johnson]

On Mon, Feb 08, 2021 at 12:01:57PM -0800, Randy Dunlap wrote:
> Hi,
> Just a couple of nits below:
> 
> On 2/8/21 7:12 AM, Calvin Johnson wrote:
> > Introduce ACPI mechanism to get PHYs registered on a MDIO bus and
> > provide them to be connected to MAC.
> > 
> > Describe properties "phy-handle" and "phy-mode".
> > 
> > Signed-off-by: Calvin Johnson <calvin.johnson at oss.nxp.com>
> > ---
> 
> >  Documentation/firmware-guide/acpi/dsd/phy.rst | 133 ++++++++++++++++++
> >  1 file changed, 133 insertions(+)
> >  create mode 100644 Documentation/firmware-guide/acpi/dsd/phy.rst
> > 
> > diff --git a/Documentation/firmware-guide/acpi/dsd/phy.rst b/Documentation/firmware-guide/acpi/dsd/phy.rst
> > new file mode 100644
> > index 000000000000..e1e99cae5eb2
> > --- /dev/null
> > +++ b/Documentation/firmware-guide/acpi/dsd/phy.rst
> > @@ -0,0 +1,133 @@
> > +.. SPDX-License-Identifier: GPL-2.0
> > +
> > +=========================
> > +MDIO bus and PHYs in ACPI
> > +=========================
> > +
> > +The PHYs on an MDIO bus [1] are probed and registered using
> > +fwnode_mdiobus_register_phy().
> > +
> > +Later, for connecting these PHYs to MAC, the PHYs registered on the
> 
>                                     to a MAC,
Each PHY is connected to a MAC. So I'll change it to "PHYs to their respective MACs".
> 
> > +MDIO bus have to be referenced.
> > +
> > +This document introduces two _DSD properties that are to be used
> > +for connecting PHYs on the MDIO bus [3] to the MAC layer.
> > +
> > +These properties are defined in accordance with the "Device
> > +Properties UUID For _DSD" [2] document and the
> > +daffd814-6eba-4d8c-8a91-bc9bbf4aa301 UUID must be used in the Device
> > +Data Descriptors containing them.
> > +
> > +phy-handle
> > +----------
> 
> ...
> 
> > +
> > +Later, during the MAC driver initialization, the registered PHY devices
> > +have to be retrieved from the MDIO bus. For this, the MAC driver need
> 
>                                                                     needs
> 
> > +references to the previously registered PHYs which are provided
> > +as device object references (e.g. \_SB.MDI0.PHY1).
> 
> 
> thanks.
> -- 
> ~Randy
>