[PATCH v4 4/5] dts: marvell: Enable 10G interface on 9130-DB board

[Marcin Wojtas]

Hi,


wt., 9 lut 2021 o 14:47 <kostap at marvell.com> napisał(a):
>
> From: Stefan Chulski <stefanc at marvell.com>
>
> This patch enables eth0 10G interface on CN9130-DB paltforms.
>
> Signed-off-by: Stefan Chulski <stefanc at marvell.com>
> Signed-off-by: Konstantin Porotchkin <kostap at marvell.com>
> ---
>  arch/arm64/boot/dts/marvell/cn9130-db.dtsi | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm64/boot/dts/marvell/cn9130-db.dtsi b/arch/arm64/boot/dts/marvell/cn9130-db.dtsi
> index 8de3a552b806..97c74b81fd78 100644
> --- a/arch/arm64/boot/dts/marvell/cn9130-db.dtsi
> +++ b/arch/arm64/boot/dts/marvell/cn9130-db.dtsi
> @@ -125,7 +125,7 @@
>
>  /* SLM-1521-V2, CON9 */
>  &cp0_eth0 {
> -       status = "disabled";
> +       status = "okay";
>         phy-mode = "10gbase-kr";
>         /* Generic PHY, providing serdes lanes */
>         phys = <&cp0_comphy4 0>;
> --
> 2.17.1
>

You can add my:
Tested-by: Marcin Wojtas <mw at semihalf.com>

Please do the same for cp1_eth0?

Best regards,
Marcin