[PATCH 13/18] arm64: ioremap: use nGnRnE mappings on platforms that require it

[Mark Kettenis]

> From: Arnd Bergmann <arnd at kernel.org>
> Date: Tue, 9 Feb 2021 10:15:31 +0100
> 
> On Tue, Feb 9, 2021 at 1:25 AM Hector Martin <marcan at marcan.st> wrote:
> > On 09/02/2021 08.20, Mark Kettenis wrote:
> > I probed writing to i<<28 for i = [0..255], using nGnRE. This reveals
> > that nGnRE writes are allowed (i.e. either succeed or error out
> > differently) in the following ranges:
> >
> > 0x400000000 - 0x4ffffffff (apciec0)
> > 0x580000000 - 0x67fffffff (apciec1)
> > 0x6a0000000 - 0x6ffffffff (apcie)
> >
> > Which matches the `ranges` properties of the respective apcie devices in
> > the ADT.
> 
> Right, these are the same ranges that I found in the adt and that Mark
> listed in his code snippet, so it seems we all see the same partitioning
> of the address space. I also see them reflected in the
> /defaults/pmap-io-ranges property in ADT, which seems to have an entry
> for every register range that has some mmio registers, along with what
> appears to be a bitmask of some attributes, and it clearly shows
> the above ranges as having a distinct set of bits from the others
> (in little-endian):
> 
>  00000000 04000000 00000080 00000000 27000080 65494350
>  00000080 04000000 00000080 00000000 27000080 65494350
>  00000080 05000000 00000080 00000000 27000080 65494350
>  00000000 06000000 00000080 00000000 27000080 65494350
>  000000a0 06000000 00000020 00000000 27000080 65494350
>  000000c0 06000000 00000040 00000000 27000080 65494350
>    ^64-bit address       ^64-bit length            ^ 64-bit flags?
> 
> As opposed to e.g.
> 
>  0000f002 05000000 00400000 00000000 07400000 54524144
>  0000f802 05000000 00400000 00000000 07400000 54524144
>  00800021 05000000 00400000 00000000 07400000 44495344
>  0000a801 05000000 00400000 00000000 07400000 54524144
> 00000367 02000000 00400000 00000000 07400000 54524144
> ...
> 
> There is one more entry for the 0x700000000-0x7ffffffff range, which
> has yet another distinct bitmask, but does not seem to correspond
> to any registers listed in other nodes.
> 
> > The first two are obviously the TB3 ports, and have more
> > features (three ranges instead of two, presumably IO port ranges are
> > supported on those, there's some extra DMA stuff, etc).
> 
> The PCI ranges property identifies these as 64-bit prefetchable (0x43),
> 32-bit non-prefetchable (0x02), and 32-bit pre prefetchable (0x42)
> respectively. The third bus only lacks the 32-bit prefetchable range,
> that is normally ok. Is this the NVMe host or something else?

Third bus has Broadcom WiFi, Fresco Logic xHCI and Broadcom Ethernet,
so all the onboard PCIe devices.