[PATCH 02/16] dt-bindings: net: Add Baikal-T1 GMAC bindings

[Serge Semin]

Baikal-T1 SoC is equipped with two DW GMAC v3.73a-based 1GBE ethernet
interfaces synthesized with: RGMII PHY interface, AXI-DMA and APB3 CSR,
16KB Tx/Rx FIFOs and PBL up to half of that, PTP, PMT, TCP/IP CoE, up to 4
outstanding AXI read/write requests, maximum AXI burst length of 16 beats,
up to eight MAC address slots, one GPI and one GPO ports. Generic DW
MAC/STMMAC driver will easily handle the DT-node describing the Baikal-T1
GMAC network devices, but the bindings still needs to be created to have a
better understanding of what the interface looks like.

Signed-off-by: Serge Semin <Sergey.Semin at baikalelectronics.ru>

---

Rob, please note I couldn't declare the axi-config object properties constraints
without specifying the properties type and description. If I remove them the
dt_binding_check will curse with the error:

>> .../baikal,bt1-gmac.yaml: properties:axi-config:properties:snps,blen: 'description' is a required property
>> .../baikal,bt1-gmac.yaml: properties:axi-config:properties:snps,wr_osr_lmt: 'oneOf' conditional failed, one must be fixed:
        'type' is a required property
        Additional properties are not allowed ('maximum' was unexpected)
>> ...

I did't know what to do with these errors, so I just created normal sub-node
properties with stricter constraints than they are specified in the main
snps,dwmac.yaml schema. Any suggestion what is a better way to apply
additional constraints on sub-node properties?
---
 .../bindings/net/baikal,bt1-gmac.yaml         | 150 ++++++++++++++++++
 1 file changed, 150 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/net/baikal,bt1-gmac.yaml

diff --git a/Documentation/devicetree/bindings/net/baikal,bt1-gmac.yaml b/Documentation/devicetree/bindings/net/baikal,bt1-gmac.yaml
new file mode 100644
index 000000000000..30ab74a9023d
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/baikal,bt1-gmac.yaml
@@ -0,0 +1,150 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+# Copyright (C) 2020 BAIKAL ELECTRONICS, JSC
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/net/baikal,bt1-gmac.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Baikal-T1 DW GMAC Network Interface
+
+maintainers:
+  - Serge Semin <fancer.lancer at gmail.com>
+
+description:
+  Baikal-T1 is equipped with two DW GMAC v3.73a network interfaces. Each of
+  them doesn't have any on-SoC PHY attached, but instead exports RGMII
+  interface to connect any compatible physical layer transceiver.
+
+select:
+  properties:
+    compatible:
+      contains:
+        const: baikal,bt1-gmac
+
+  required:
+    - compatible
+
+allOf:
+  - $ref: "snps,dwmac.yaml#"
+
+properties:
+  compatible:
+    items:
+      - const: baikal,bt1-gmac
+      - const: snps,dwmac-3.73a
+      - const: snps,dwmac
+
+  reg:
+    maxItems: 1
+
+  interrupts:
+    maxItems: 1
+
+  interrupt-names:
+    const: macirq
+
+  clocks:
+    minItems: 4
+    maxItems: 4
+
+  clock-names:
+    minItems: 4
+    maxItems: 4
+    contains:
+      enum:
+        - stmmaceth
+        - pclk
+        - tx
+        - ptp_ref
+
+  ngpios:
+    description:
+      Baikal-T1 GMAC have been created with one GPI and one GPO ports
+      enabled. So there are total two GPIOs available.
+    const: 2
+
+  gpio-controller: true
+
+  "#gpio-cells":
+    const: 2
+
+  tx-internal-delay-ps:
+    description:
+      DW MAC Tx clocks generator has been designed to always add 2ns delay
+      of TXC with respect to TXD.
+    const: 2000
+
+  rx-fifo-depth:
+    const: 16384
+
+  tx-fifo-depth:
+    const: 16384
+
+  axi-config:
+    type: object
+
+    properties:
+      snps,wr_osr_lmt:
+        $ref: /schemas/types.yaml#/definitions/uint32
+        description: Maximum write outstanding requests is limited with 4
+        maximum: 3
+
+      snps,rd_osr_lmt:
+        $ref: /schemas/types.yaml#/definitions/uint32
+        description: Maximum read outstanding requests is limited with 4
+        maximum: 3
+
+      snps,blen:
+        $ref: /schemas/types.yaml#/definitions/uint32-array
+        description: AXI-bus burst length width is limited with just 4 bits
+        items:
+          enum: [16, 8, 4, 0]
+
+required:
+  - compatible
+  - reg
+  - interrupts
+  - interrupt-names
+  - clocks
+  - clock-names
+  - resets
+  - reset-names
+  - phy-mode
+
+unevaluatedProperties: false
+
+examples:
+  - |
+    ethernet at 1f05e000 {
+      compatible = "baikal,bt1-dwmac", "snps,dwmac-3.73a", "snps,dwmac";
+      reg = <0x1f05e000 0x2000>;
+      #address-cells = <1>;
+      #size-cells = <2>;
+
+      interrupts = <72>;
+      interrupt-names = "macirq";
+
+      clocks = <&ccu_sys 1>, <&ccu_axi 3>, <&ccu_sys 2>, <&ccu_sys 3>;
+      clock-names = "pclk", "stmmaceth", "tx", "ptp_ref";
+
+      resets = <&ccu_axi 3>;
+      reset-names = "stmmaceth";
+
+      ngpios = <2>;
+
+      gpio-controller;
+      #gpio-cells = <2>;
+
+      phy-mode = "rgmii-rxid";
+      tx-internal-delay-ps = <2000>;
+
+      rx-fifo-depth = <16384>;
+      tx-fifo-depth = <16384>;
+
+      axi-config {
+        snps,wr_osr_lmt = <0x3>;
+        snps,rd_osr_lmt = <0x3>;
+        snps,blen = <0 0 0 0 16 8 4>;
+      };
+    };
+...
-- 
2.29.2