[PATCH 3/3] spi: mediatek: add set_cs_timing support

Leilk Liu leilk.liu at mediatek.com
Sat Feb 6 22:09:53 EST 2021


From: "leilk.liu" <leilk.liu at mediatek.com>

this patch add set_cs_timing support for HW CS mode.

Signed-off-by: leilk.liu <leilk.liu at mediatek.com>
---
 drivers/spi/spi-mt65xx.c | 72 +++++++++++++++++++++++++++++++---------
 1 file changed, 56 insertions(+), 16 deletions(-)

diff --git a/drivers/spi/spi-mt65xx.c b/drivers/spi/spi-mt65xx.c
index 5d643051bf3d..976f73b9e299 100644
--- a/drivers/spi/spi-mt65xx.c
+++ b/drivers/spi/spi-mt65xx.c
@@ -287,7 +287,7 @@ static void mtk_spi_set_cs(struct spi_device *spi, bool enable)
 static void mtk_spi_prepare_transfer(struct spi_master *master,
 				     struct spi_transfer *xfer)
 {
-	u32 spi_clk_hz, div, sck_time, cs_time, reg_val;
+	u32 spi_clk_hz, div, sck_time, reg_val;
 	struct mtk_spi *mdata = spi_master_get_devdata(master);
 
 	spi_clk_hz = clk_get_rate(mdata->spi_clk);
@@ -297,32 +297,25 @@ static void mtk_spi_prepare_transfer(struct spi_master *master,
 		div = 1;
 
 	sck_time = (div + 1) / 2;
-	cs_time = sck_time * 2;
 
 	if (mdata->dev_comp->enhance_timing) {
-		reg_val = (((sck_time - 1) & 0xffff)
+		reg_val = readl(mdata->base + SPI_CFG2_REG);
+		reg_val &= ~(0xffff << SPI_CFG2_SCK_HIGH_OFFSET);
+		reg_val |= (((sck_time - 1) & 0xffff)
 			   << SPI_CFG2_SCK_HIGH_OFFSET);
+		reg_val &= ~(0xffff << SPI_CFG2_SCK_LOW_OFFSET);
 		reg_val |= (((sck_time - 1) & 0xffff)
 			   << SPI_CFG2_SCK_LOW_OFFSET);
 		writel(reg_val, mdata->base + SPI_CFG2_REG);
-		reg_val = (((cs_time - 1) & 0xffff)
-			   << SPI_ADJUST_CFG0_CS_HOLD_OFFSET);
-		reg_val |= (((cs_time - 1) & 0xffff)
-			   << SPI_ADJUST_CFG0_CS_SETUP_OFFSET);
-		writel(reg_val, mdata->base + SPI_CFG0_REG);
 	} else {
-		reg_val = (((sck_time - 1) & 0xff)
+		reg_val = readl(mdata->base + SPI_CFG0_REG);
+		reg_val &= ~(0xff << SPI_CFG0_SCK_HIGH_OFFSET);
+		reg_val |= (((sck_time - 1) & 0xff)
 			   << SPI_CFG0_SCK_HIGH_OFFSET);
+		reg_val &= ~(0xff << SPI_CFG0_SCK_LOW_OFFSET);
 		reg_val |= (((sck_time - 1) & 0xff) << SPI_CFG0_SCK_LOW_OFFSET);
-		reg_val |= (((cs_time - 1) & 0xff) << SPI_CFG0_CS_HOLD_OFFSET);
-		reg_val |= (((cs_time - 1) & 0xff) << SPI_CFG0_CS_SETUP_OFFSET);
 		writel(reg_val, mdata->base + SPI_CFG0_REG);
 	}
-
-	reg_val = readl(mdata->base + SPI_CFG1_REG);
-	reg_val &= ~SPI_CFG1_CS_IDLE_MASK;
-	reg_val |= (((cs_time - 1) & 0xff) << SPI_CFG1_CS_IDLE_OFFSET);
-	writel(reg_val, mdata->base + SPI_CFG1_REG);
 }
 
 static void mtk_spi_setup_packet(struct spi_master *master)
@@ -513,6 +506,52 @@ static bool mtk_spi_can_dma(struct spi_master *master,
 		(unsigned long)xfer->rx_buf % 4 == 0);
 }
 
+static int mtk_spi_set_hw_cs_timing(struct spi_device *spi,
+				    struct spi_delay *setup,
+				    struct spi_delay *hold,
+				    struct spi_delay *inactive)
+{
+	struct mtk_spi *mdata = spi_master_get_devdata(spi->master);
+	u16 setup_dly, hold_dly, inactive_dly;
+	u32 reg_val;
+
+	if ((setup && setup->unit != SPI_DELAY_UNIT_SCK) ||
+	    (hold && hold->unit != SPI_DELAY_UNIT_SCK) ||
+	    (inactive && inactive->unit != SPI_DELAY_UNIT_SCK)) {
+		dev_err(&spi->dev,
+			"Invalid delay unit, should be SPI_DELAY_UNIT_SCK\n");
+		return -EINVAL;
+	}
+
+	setup_dly = setup ? setup->value : 1;
+	hold_dly = hold ? hold->value : 1;
+	inactive_dly = inactive ? inactive->value : 1;
+
+	reg_val = readl(mdata->base + SPI_CFG0_REG);
+	if (mdata->dev_comp->enhance_timing) {
+		reg_val &= ~(0xffff << SPI_ADJUST_CFG0_CS_HOLD_OFFSET);
+		reg_val |= (((hold_dly - 1) & 0xffff)
+			   << SPI_ADJUST_CFG0_CS_HOLD_OFFSET);
+		reg_val &= ~(0xffff << SPI_ADJUST_CFG0_CS_SETUP_OFFSET);
+		reg_val |= (((setup_dly - 1) & 0xffff)
+			   << SPI_ADJUST_CFG0_CS_SETUP_OFFSET);
+	} else {
+		reg_val &= ~(0xff << SPI_CFG0_CS_HOLD_OFFSET);
+		reg_val |= (((hold_dly - 1) & 0xff) << SPI_CFG0_CS_HOLD_OFFSET);
+		reg_val &= ~(0xff << SPI_CFG0_CS_SETUP_OFFSET);
+		reg_val |= (((setup_dly - 1) & 0xff)
+			    << SPI_CFG0_CS_SETUP_OFFSET);
+	}
+	writel(reg_val, mdata->base + SPI_CFG0_REG);
+
+	reg_val = readl(mdata->base + SPI_CFG1_REG);
+	reg_val &= ~SPI_CFG1_CS_IDLE_MASK;
+	reg_val |= (((inactive_dly - 1) & 0xff) << SPI_CFG1_CS_IDLE_OFFSET);
+	writel(reg_val, mdata->base + SPI_CFG1_REG);
+
+	return 0;
+}
+
 static int mtk_spi_setup(struct spi_device *spi)
 {
 	struct mtk_spi *mdata = spi_master_get_devdata(spi->master);
@@ -644,6 +683,7 @@ static int mtk_spi_probe(struct platform_device *pdev)
 	master->transfer_one = mtk_spi_transfer_one;
 	master->can_dma = mtk_spi_can_dma;
 	master->setup = mtk_spi_setup;
+	master->set_cs_timing = mtk_spi_set_hw_cs_timing;
 
 	of_id = of_match_node(mtk_spi_of_match, pdev->dev.of_node);
 	if (!of_id) {
-- 
2.18.0


More information about the linux-arm-kernel mailing list