[RFC/PATCH 05/11] soc: bcm: bcm2835-power: Add support for BCM2711's ARSAN ASB
Nicolas Saenz Julienne
nsaenzjulienne at suse.de
Fri Feb 5 13:30:46 EST 2021
Hi Florian, Phil,
On Fri, 2021-02-05 at 08:56 -0800, Florian Fainelli wrote:
> On 2/5/21 5:52 AM, Nicolas Saenz Julienne wrote:
> > In BCM2711 the new ARGON ASB took over V3D. The old ASB is still present
> > with the ISP and H264 bits, and V3D is in the same place in the new ASB
> > as the old one.
> > Use the fact that 'pm->arsan_asb' is populated as a hint that we're on
> > BCM2711. On top of that introduce the macro ASB_BASE() which will select
> > the correct ASB register base, based on whether we're trying to access
> > V3D and which platform we're on.
> Your subject has a typo, you most likely intended to write "Argon ASB",
Yes, sorry for that, the typo is also present in code. I mindlessly decided
both words meant the same and went with it...
So, for the record, s/arsan/argon/ should be applied on all patches, binding is
fine in that regards. On the other hand, the old arsan/rpivid ASB is referenced
as 'asb' in code, and as 'arsan' in the bindings, I'll rename both to 'rpivid'
Actually, if all this is too confusing, let me know and I'll send a v2 right
> I will review the series a little later today.
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 488 bytes
Desc: This is a digitally signed message part
More information about the linux-arm-kernel