[PATCH] drivers: net: ehternet: i825xx: Fix couple of spellings in the file ether1.c
Bhaskar Chowdhury
unixbhaskar at gmail.com
Wed Feb 3 10:15:47 EST 2021
s/initialsation/initialisation/
s/specifiing/specifying/
Signed-off-by: Bhaskar Chowdhury <unixbhaskar at gmail.com>
---
drivers/net/ethernet/i825xx/ether1.c | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)
diff --git a/drivers/net/ethernet/i825xx/ether1.c b/drivers/net/ethernet/i825xx/ether1.c
index a0bfb509e002..0233fb6e222d 100644
--- a/drivers/net/ethernet/i825xx/ether1.c
+++ b/drivers/net/ethernet/i825xx/ether1.c
@@ -20,7 +20,7 @@
* 1.02 RMK 25/05/1997 Added code to restart RU if it goes not ready
* 1.03 RMK 14/09/1997 Cleaned up the handling of a reset during the TX interrupt.
* Should prevent lockup.
- * 1.04 RMK 17/09/1997 Added more info when initialsation of chip goes wrong.
+ * 1.04 RMK 17/09/1997 Added more info when initialisation of chip goes wrong.
* TDR now only reports failure when chip reports non-zero
* TDR time-distance.
* 1.05 RMK 31/12/1997 Removed calls to dev_tint for 2.1
@@ -117,7 +117,7 @@ ether1_outw_p (struct net_device *dev, unsigned short val, int addr, int svflgs)
* Some inline assembler to allow fast transfers on to/off of the card.
* Since this driver depends on some features presented by the ARM
* specific architecture, and that you can't configure this driver
- * without specifiing ARM mode, this is not a problem.
+ * without specifying ARM mode, this is not a problem.
*
* This routine is essentially an optimised memcpy from the card's
* onboard RAM to kernel memory.
@@ -885,7 +885,7 @@ ether1_recv_done (struct net_device *dev)
ether1_writew(dev, 0, priv(dev)->rx_tail, rfd_t, rfd_command, NORMALIRQS);
ether1_writew(dev, 0, priv(dev)->rx_tail, rfd_t, rfd_status, NORMALIRQS);
ether1_writew(dev, 0, priv(dev)->rx_tail, rfd_t, rfd_rbdoffset, NORMALIRQS);
-
+
priv(dev)->rx_tail = nexttail;
priv(dev)->rx_head = ether1_readw(dev, priv(dev)->rx_head, rfd_t, rfd_link, NORMALIRQS);
} while (1);
@@ -1031,7 +1031,7 @@ ether1_probe(struct expansion_card *ec, const struct ecard_id *id)
printk(KERN_INFO "%s: ether1 in slot %d, %pM\n",
dev->name, ec->slot_no, dev->dev_addr);
-
+
ecard_set_drvdata(ec, dev);
return 0;
@@ -1047,7 +1047,7 @@ static void ether1_remove(struct expansion_card *ec)
{
struct net_device *dev = ecard_get_drvdata(ec);
- ecard_set_drvdata(ec, NULL);
+ ecard_set_drvdata(ec, NULL);
unregister_netdev(dev);
free_netdev(dev);
--
2.26.2
More information about the linux-arm-kernel
mailing list