[PATCH 1/5] arm64: dts: exynos: Align MAX77843 nodes with dtschema on TM2

[Krzysztof Kozlowski]

The newly introduced dtschema for MAX77843 MUIC require the children to
have proper naming and a port at 0 property.

This should not have actual impact on MFD children driver binding,
because the max77843 MFD driver uses compatibles.  The port at 0 is
disabled to avoid any impact.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at canonical.com>

---

Please kindly test or even better - fix the DTS and extcon driver.
---
 .../boot/dts/exynos/exynos5433-tm2-common.dtsi  | 17 ++++++++++++++---
 1 file changed, 14 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2-common.dtsi b/arch/arm64/boot/dts/exynos/exynos5433-tm2-common.dtsi
index cbcc01a66aab..03f7c9acaacb 100644
--- a/arch/arm64/boot/dts/exynos/exynos5433-tm2-common.dtsi
+++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2-common.dtsi
@@ -858,10 +858,10 @@ pmic at 66 {
 		interrupts = <5 IRQ_TYPE_EDGE_FALLING>;
 		reg = <0x66>;
 
-		muic: max77843-muic {
+		muic: extcon {
 			compatible = "maxim,max77843-muic";
 
-			musb_con: musb-connector {
+			musb_con: connector {
 				compatible = "samsung,usb-connector-11pin",
 					     "usb-b-connector";
 				label = "micro-USB";
@@ -871,6 +871,17 @@ ports {
 					#address-cells = <1>;
 					#size-cells = <0>;
 
+					port at 0 {
+						/*
+						 * TODO: The DTS this is based on does not have
+						 * port at 0 which is a required property. The ports
+						 * look incomplete and need fixing.
+						 * Add a disabled port just to satisfy dtschema.
+						 */
+						reg = <0>;
+						status = "disabled";
+					};
+
 					port at 3 {
 						reg = <3>;
 						musb_con_to_mhl: endpoint {
@@ -910,7 +921,7 @@ charger_reg: CHARGER {
 			};
 		};
 
-		haptic: max77843-haptic {
+		haptic: motor-driver {
 			compatible = "maxim,max77843-haptic";
 			haptic-supply = <&ldo38_reg>;
 			pwms = <&pwm 0 33670 0>;
-- 
2.32.0