[PATCH v2 2/3] i2c: sh_mobile: Use platform_get_irq_optional() to get the interrupt
Andy Shevchenko
andy.shevchenko at gmail.com
Sat Dec 25 09:48:46 PST 2021
On Wed, Dec 22, 2021 at 2:41 PM Lad Prabhakar
<prabhakar.mahadev-lad.rj at bp.renesas.com> wrote:
>
> platform_get_resource(pdev, IORESOURCE_IRQ, ..) relies on static
> allocation of IRQ resources in DT core code, this causes an issue
> when using hierarchical interrupt domains using "interrupts" property
> in the node as this bypasses the hierarchical setup and messes up the
> irq chaining.
>
> In preparation for removal of static setup of IRQ resource from DT core
> code use platform_get_irq_optional() for DT users only.
...
> + if (np) {
Same comments as per your other patches, i.e.
Why is this check here?
> + int irq;
> +
> + while ((irq = platform_get_irq_optional(dev, k)) != -ENXIO) {
Consider 0 as no IRQ.
> + if (irq < 0)
> + return irq;
> + ret = devm_request_irq(&dev->dev, irq, sh_mobile_i2c_isr,
> + 0, dev_name(&dev->dev), pd);
> if (ret) {
> - dev_err(&dev->dev, "cannot request IRQ %pa\n", &n);
> + dev_err(&dev->dev, "cannot request IRQ %d\n", irq);
> return ret;
> }
> + k++;
> + };
> + } else {
> + struct resource *res;
> + resource_size_t n;
> +
> + while ((res = platform_get_resource(dev, IORESOURCE_IRQ, k))) {
> + for (n = res->start; n <= res->end; n++) {
> + ret = devm_request_irq(&dev->dev, n, sh_mobile_i2c_isr,
> + 0, dev_name(&dev->dev), pd);
> + if (ret) {
> + dev_err(&dev->dev, "cannot request IRQ %pa\n", &n);
> + return ret;
> + }
> + }
> + k++;
> }
> - k++;
> }
--
With Best Regards,
Andy Shevchenko
More information about the linux-arm-kernel
mailing list