[PATCH 09/10] serial: bcm63xx: Use platform_get_irq() to get the interrupt

[Lad Prabhakar]

platform_get_resource(pdev, IORESOURCE_IRQ, ..) relies on static
allocation of IRQ resources in DT core code, this causes an issue
when using hierarchical interrupt domains using "interrupts" property
in the node as this bypasses the hierarchical setup and messes up the
irq chaining.

In preparation for removal of static setup of IRQ resource from DT core
code use platform_get_irq().

Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj at bp.renesas.com>
---
 drivers/tty/serial/bcm63xx_uart.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/tty/serial/bcm63xx_uart.c b/drivers/tty/serial/bcm63xx_uart.c
index 5fb0e84f7fd1..6471a54b616b 100644
--- a/drivers/tty/serial/bcm63xx_uart.c
+++ b/drivers/tty/serial/bcm63xx_uart.c
@@ -804,7 +804,7 @@ static struct uart_driver bcm_uart_driver = {
  */
 static int bcm_uart_probe(struct platform_device *pdev)
 {
-	struct resource *res_mem, *res_irq;
+	struct resource *res_mem;
 	struct uart_port *port;
 	struct clk *clk;
 	int ret;
@@ -833,9 +833,10 @@ static int bcm_uart_probe(struct platform_device *pdev)
 	if (IS_ERR(port->membase))
 		return PTR_ERR(port->membase);
 
-	res_irq = platform_get_resource(pdev, IORESOURCE_IRQ, 0);
-	if (!res_irq)
-		return -ENODEV;
+	ret = platform_get_irq(pdev, 0);
+	if (ret < 0)
+		return ret;
+	port->irq = ret;
 
 	clk = clk_get(&pdev->dev, "refclk");
 	if (IS_ERR(clk) && pdev->dev.of_node)
@@ -845,7 +846,6 @@ static int bcm_uart_probe(struct platform_device *pdev)
 		return -ENODEV;
 
 	port->iotype = UPIO_MEM;
-	port->irq = res_irq->start;
 	port->ops = &bcm_uart_ops;
 	port->flags = UPF_BOOT_AUTOCONF;
 	port->dev = &pdev->dev;
-- 
2.17.1