[PATCH 1/3] i2c: bcm2835: Use platform_get_irq() to get the interrupt

[Florian Fainelli]

On 12/18/2021 8:52 AM, Lad Prabhakar wrote:
> platform_get_resource(pdev, IORESOURCE_IRQ, ..) relies on static
> allocation of IRQ resources in DT core code, this causes an issue
> when using hierarchical interrupt domains using "interrupts" property
> in the node as this bypasses the hierarchical setup and messes up the
> irq chaining.
> 
> In preparation for removal of static setup of IRQ resource from DT core
> code use platform_get_irq().
> 
> Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj at bp.renesas.com>

Just one nit below:
> ---
>   drivers/i2c/busses/i2c-bcm2835.c | 11 ++++-------
>   1 file changed, 4 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/i2c/busses/i2c-bcm2835.c b/drivers/i2c/busses/i2c-bcm2835.c
> index 37443edbf754..d63dec5f3cb1 100644
> --- a/drivers/i2c/busses/i2c-bcm2835.c
> +++ b/drivers/i2c/busses/i2c-bcm2835.c
> @@ -402,7 +402,7 @@ static const struct i2c_adapter_quirks bcm2835_i2c_quirks = {
>   static int bcm2835_i2c_probe(struct platform_device *pdev)
>   {
>   	struct bcm2835_i2c_dev *i2c_dev;
> -	struct resource *mem, *irq;
> +	struct resource *mem;
>   	int ret;
>   	struct i2c_adapter *adap;
>   	struct clk *mclk;
> @@ -452,12 +452,9 @@ static int bcm2835_i2c_probe(struct platform_device *pdev)
>   		return ret;
>   	}
>   
> -	irq = platform_get_resource(pdev, IORESOURCE_IRQ, 0);
> -	if (!irq) {
> -		dev_err(&pdev->dev, "No IRQ resource\n");
> -		return -ENODEV;
> -	}
> -	i2c_dev->irq = irq->start;
> +	i2c_dev->irq = platform_get_irq(pdev, 0);
> +	if (i2c_dev->irq <= 0)
> +		return i2c_dev->irq ? i2c_dev->irq : -ENXIO;

Why not just check for a negative return code and propagate it as is?
-- 
Florian