[PATCH 3/3] i2c: riic: Use platform_get_irq() to get the interrupt

[Lad Prabhakar]

platform_get_resource(pdev, IORESOURCE_IRQ, ..) relies on static
allocation of IRQ resources in DT core code, this causes an issue
when using hierarchical interrupt domains using "interrupts" property
in the node as this bypasses the hierarchical setup and messes up the
irq chaining.

In preparation for removal of static setup of IRQ resource from DT core
code use platform_get_irq().

Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj at bp.renesas.com>
---
 drivers/i2c/busses/i2c-riic.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/i2c/busses/i2c-riic.c b/drivers/i2c/busses/i2c-riic.c
index 78b84445ee6a..f18b9fe86d4b 100644
--- a/drivers/i2c/busses/i2c-riic.c
+++ b/drivers/i2c/busses/i2c-riic.c
@@ -433,12 +433,12 @@ static int riic_i2c_probe(struct platform_device *pdev)
 	}
 
 	for (i = 0; i < ARRAY_SIZE(riic_irqs); i++) {
-		res = platform_get_resource(pdev, IORESOURCE_IRQ, riic_irqs[i].res_num);
-		if (!res)
-			return -ENODEV;
+		ret = platform_get_irq(pdev, riic_irqs[i].res_num);
+		if (ret <= 0)
+			return ret ? ret : -ENXIO;
 
-		ret = devm_request_irq(&pdev->dev, res->start, riic_irqs[i].isr,
-					0, riic_irqs[i].name, riic);
+		ret = devm_request_irq(&pdev->dev, ret, riic_irqs[i].isr,
+				       0, riic_irqs[i].name, riic);
 		if (ret) {
 			dev_err(&pdev->dev, "failed to request irq %s\n", riic_irqs[i].name);
 			return ret;
-- 
2.17.1