[RESEND v4 02/10] arm64: dts: freescale: Add the top level dtsi support for imx8dxl
Abel Vesa
abel.vesa at nxp.com
Thu Dec 16 10:48:06 PST 2021
From: Jacky Bai <ping.bai at nxp.com>
The i.MX8DXL is a device targeting the automotive and industrial
market segments. The flexibility of the architecture allows for
use in a wide variety of general embedded applications. The chip
is designed to achieve both high performance and low power consumption.
The chip relies on the power efficient dual (2x) Cortex-A35 cluster.
Add the reserved memory node property for dsp reserved memory,
the wakeup-irq property for SCU node, the imx ion, the rpmsg and the
cm4 rproc support.
Signed-off-by: Jacky Bai <ping.bai at nxp.com>
Signed-off-by: Abel Vesa <abel.vesa at nxp.com>
---
arch/arm64/boot/dts/freescale/imx8dxl.dtsi | 245 +++++++++++++++++++++
1 file changed, 245 insertions(+)
create mode 100644 arch/arm64/boot/dts/freescale/imx8dxl.dtsi
diff --git a/arch/arm64/boot/dts/freescale/imx8dxl.dtsi b/arch/arm64/boot/dts/freescale/imx8dxl.dtsi
new file mode 100644
index 000000000000..f16f88882c39
--- /dev/null
+++ b/arch/arm64/boot/dts/freescale/imx8dxl.dtsi
@@ -0,0 +1,245 @@
+// SPDX-License-Identifier: GPL-2.0+
+/*
+ * Copyright 2019-2021 NXP
+ */
+
+#include <dt-bindings/clock/imx8-clock.h>
+#include <dt-bindings/firmware/imx/rsrc.h>
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/interrupt-controller/arm-gic.h>
+#include <dt-bindings/input/input.h>
+#include <dt-bindings/pinctrl/pads-imx8dxl.h>
+#include <dt-bindings/thermal/thermal.h>
+
+/ {
+ interrupt-parent = <&gic>;
+ #address-cells = <2>;
+ #size-cells = <2>;
+
+ aliases {
+ ethernet0 = &fec1;
+ ethernet1 = &eqos;
+ gpio0 = &lsio_gpio0;
+ gpio1 = &lsio_gpio1;
+ gpio2 = &lsio_gpio2;
+ gpio3 = &lsio_gpio3;
+ gpio4 = &lsio_gpio4;
+ gpio5 = &lsio_gpio5;
+ gpio6 = &lsio_gpio6;
+ gpio7 = &lsio_gpio7;
+ i2c2 = &i2c2;
+ i2c3 = &i2c3;
+ mmc0 = &usdhc1;
+ mmc1 = &usdhc2;
+ mu1 = &lsio_mu1;
+ serial0 = &lpuart0;
+ serial1 = &lpuart1;
+ serial2 = &lpuart2;
+ serial3 = &lpuart3;
+ };
+
+ cpus: cpus {
+ #address-cells = <2>;
+ #size-cells = <0>;
+
+ /* We have 1 clusters with 2 Cortex-A35 cores */
+ A35_0: cpu at 0 {
+ device_type = "cpu";
+ compatible = "arm,cortex-a35";
+ reg = <0x0 0x0>;
+ enable-method = "psci";
+ next-level-cache = <&A35_L2>;
+ clocks = <&clk IMX_SC_R_A35 IMX_SC_PM_CLK_CPU>;
+ #cooling-cells = <2>;
+ operating-points-v2 = <&a35_opp_table>;
+ };
+
+ A35_1: cpu at 1 {
+ device_type = "cpu";
+ compatible = "arm,cortex-a35";
+ reg = <0x0 0x1>;
+ enable-method = "psci";
+ next-level-cache = <&A35_L2>;
+ clocks = <&clk IMX_SC_R_A35 IMX_SC_PM_CLK_CPU>;
+ #cooling-cells = <2>;
+ operating-points-v2 = <&a35_opp_table>;
+ };
+
+ A35_L2: l2-cache0 {
+ compatible = "cache";
+ };
+ };
+
+ a35_opp_table: opp-table {
+ compatible = "operating-points-v2";
+ opp-shared;
+
+ opp-900000000 {
+ opp-hz = /bits/ 64 <900000000>;
+ opp-microvolt = <1000000>;
+ clock-latency-ns = <150000>;
+ };
+
+ opp-1200000000 {
+ opp-hz = /bits/ 64 <1200000000>;
+ opp-microvolt = <1100000>;
+ clock-latency-ns = <150000>;
+ opp-suspend;
+ };
+ };
+
+ reserved-memory {
+ #address-cells = <2>;
+ #size-cells = <2>;
+ ranges;
+
+ dsp_reserved: dsp at 92400000 {
+ reg = <0 0x92400000 0 0x2000000>;
+ no-map;
+ };
+ };
+
+ gic: interrupt-controller at 51a00000 {
+ compatible = "arm,gic-v3";
+ reg = <0x0 0x51a00000 0 0x10000>, /* GIC Dist */
+ <0x0 0x51b00000 0 0xc0000>; /* GICR (RD_base + SGI_base) */
+ #interrupt-cells = <3>;
+ interrupt-controller;
+ interrupts = <GIC_PPI 9 IRQ_TYPE_LEVEL_HIGH>;
+ };
+
+ pmu {
+ compatible = "arm,armv8-pmuv3";
+ interrupts = <GIC_PPI 7 IRQ_TYPE_LEVEL_HIGH>;
+ };
+
+ psci {
+ compatible = "arm,psci-1.0";
+ method = "smc";
+ };
+
+ scu {
+ compatible = "fsl,imx-scu";
+ mbox-names = "tx0",
+ "rx0",
+ "gip3";
+ mboxes = <&lsio_mu1 0 0
+ &lsio_mu1 1 0
+ &lsio_mu1 3 3>;
+
+ pd: imx8dxl-pd {
+ compatible = "fsl,imx8dxl-scu-pd", "fsl,scu-pd";
+ #power-domain-cells = <1>;
+ };
+
+ clk: clock-controller {
+ compatible = "fsl,imx8dxl-clk", "fsl,scu-clk";
+ #clock-cells = <2>;
+ clocks = <&xtal32k &xtal24m>;
+ clock-names = "xtal_32KHz", "xtal_24Mhz";
+ };
+
+ iomuxc: pinctrl {
+ compatible = "fsl,imx8dxl-iomuxc";
+ };
+
+ ocotp: imx8qx-ocotp {
+ compatible = "fsl,imx8dxl-scu-ocotp", "fsl,imx8qxp-scu-ocotp";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ fec_mac0: mac at 2c4 {
+ reg = <0x2c4 6>;
+ };
+
+ fec_mac1: mac at 2c6 {
+ reg = <0x2c6 6>;
+ };
+ };
+
+ watchdog {
+ compatible = "fsl,imx-sc-wdt";
+ timeout-sec = <60>;
+ };
+
+ tsens: thermal-sensor {
+ compatible = "fsl,imx-sc-thermal";
+ #thermal-sensor-cells = <1>;
+ };
+ };
+
+ timer {
+ compatible = "arm,armv8-timer";
+ interrupts = <GIC_PPI 13 IRQ_TYPE_LEVEL_LOW>, /* Physical Secure */
+ <GIC_PPI 14 IRQ_TYPE_LEVEL_LOW>, /* Physical Non-Secure */
+ <GIC_PPI 11 IRQ_TYPE_LEVEL_LOW>, /* Virtual */
+ <GIC_PPI 10 IRQ_TYPE_LEVEL_LOW>; /* Hypervisor */
+ };
+
+ thermal_zones: thermal-zones {
+ cpu-thermal0 {
+ polling-delay-passive = <250>;
+ polling-delay = <2000>;
+ thermal-sensors = <&tsens IMX_SC_R_SYSTEM>;
+
+ trips {
+ cpu_alert0: trip0 {
+ temperature = <107000>;
+ hysteresis = <2000>;
+ type = "passive";
+ };
+ cpu_crit0: trip1 {
+ temperature = <127000>;
+ hysteresis = <2000>;
+ type = "critical";
+ };
+ };
+ cooling-maps {
+ map0 {
+ trip = <&cpu_alert0>;
+ cooling-device =
+ <&A35_0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
+ <&A35_1 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
+ };
+ };
+ };
+ };
+
+ clk_dummy: clock-dummy {
+ compatible = "fixed-clock";
+ #clock-cells = <0>;
+ clock-frequency = <0>;
+ clock-output-names = "clk_dummy";
+ };
+
+ xtal32k: clock-xtal32k {
+ compatible = "fixed-clock";
+ #clock-cells = <0>;
+ clock-frequency = <32768>;
+ clock-output-names = "xtal_32KHz";
+ };
+
+ xtal24m: clock-xtal24m {
+ compatible = "fixed-clock";
+ #clock-cells = <0>;
+ clock-frequency = <24000000>;
+ clock-output-names = "xtal_24MHz";
+ };
+
+ sc_pwrkey: sc-powerkey {
+ compatible = "fsl,imx8-pwrkey";
+ linux,keycode = <KEY_POWER>;
+ wakeup-source;
+ };
+
+ /* sorted in register address */
+ #include "imx8-ss-adma.dtsi"
+ #include "imx8-ss-conn.dtsi"
+ #include "imx8-ss-ddr.dtsi"
+ #include "imx8-ss-lsio.dtsi"
+};
+
+#include "imx8dxl-ss-adma.dtsi"
+#include "imx8dxl-ss-conn.dtsi"
+#include "imx8dxl-ss-lsio.dtsi"
+#include "imx8dxl-ss-ddr.dtsi"
--
2.31.1
More information about the linux-arm-kernel
mailing list