[PATCH v7 3/4] perf/marvell: cn10k DDR perfmon event overflow handling
Bharat Bhushan
bbhushan2 at marvell.com
Tue Dec 14 08:56:12 PST 2021
CN10k DSS h/w perfmon does not support event overflow interrupt, so
periodic timer is being used. Each event counter is 48bit, which in worst
case scenario can increment at maximum 5.6 GT/s. At this rate it may take
many hours to overflow these counters. Therefore polling period for
overflow is set to 100 sec, which can be changed using sysfs parameter.
Two fixed event counters starts counting from zero on overflow, so
overflow condition is when new count less than previous count. While
eight programmable event counters freezes at maximum value. Also individual
counter cannot be restarted, so need to restart all eight counters.
Signed-off-by: Bharat Bhushan <bbhushan2 at marvell.com>
Reviewed-by: Bhaskara Budiredla <bbudiredla at marvell.com>
---
v3->v7
- No Change
v2->v3:
- uintXX_t -> uXX
v1->v2:
- No Change
drivers/perf/marvell_cn10k_ddr_pmu.c | 111 +++++++++++++++++++++++++++
1 file changed, 111 insertions(+)
diff --git a/drivers/perf/marvell_cn10k_ddr_pmu.c b/drivers/perf/marvell_cn10k_ddr_pmu.c
index 9b6d5e716b94..21fccb9090c5 100644
--- a/drivers/perf/marvell_cn10k_ddr_pmu.c
+++ b/drivers/perf/marvell_cn10k_ddr_pmu.c
@@ -11,6 +11,7 @@
#include <linux/of_address.h>
#include <linux/of_device.h>
#include <linux/perf_event.h>
+#include <linux/hrtimer.h>
/* Performance Counters Operating Mode Control Registers */
#define DDRC_PERF_CNT_OP_MODE_CTRL 0x8020
@@ -127,6 +128,7 @@ struct cn10k_ddr_pmu {
struct device *dev;
int active_events;
struct perf_event *events[DDRC_PERF_NUM_COUNTERS];
+ struct hrtimer hrtimer;
};
#define to_cn10k_ddr_pmu(p) container_of(p, struct cn10k_ddr_pmu, pmu)
@@ -251,6 +253,18 @@ static const struct attribute_group *cn10k_attr_groups[] = {
NULL,
};
+/* Default poll timeout is 100 sec, which is very sufficient for
+ * 48 bit counter incremented max at 5.6 GT/s, which may take many
+ * hours to overflow.
+ */
+static unsigned long cn10k_ddr_pmu_poll_period_sec = 100;
+module_param_named(poll_period_sec, cn10k_ddr_pmu_poll_period_sec, ulong, 0644);
+
+static ktime_t cn10k_ddr_pmu_timer_period(void)
+{
+ return ms_to_ktime((u64)cn10k_ddr_pmu_poll_period_sec * USEC_PER_SEC);
+}
+
static int ddr_perf_get_event_bitmap(int eventid, u64 *event_bitmap)
{
switch (eventid) {
@@ -433,6 +447,10 @@ static int cn10k_ddr_perf_event_add(struct perf_event *event, int flags)
pmu->active_events++;
hwc->idx = counter;
+ if (pmu->active_events == 1)
+ hrtimer_start(&pmu->hrtimer, cn10k_ddr_pmu_timer_period(),
+ HRTIMER_MODE_REL_PINNED);
+
if (counter < DDRC_PERF_NUM_GEN_COUNTERS) {
/* Generic counters, configure event id */
reg_offset = DDRC_PERF_CFG(counter);
@@ -484,6 +502,10 @@ static void cn10k_ddr_perf_event_del(struct perf_event *event, int flags)
cn10k_ddr_perf_free_counter(pmu, counter);
pmu->active_events--;
hwc->idx = -1;
+
+ /* Cancel timer when no events to capture */
+ if (pmu->active_events == 0)
+ hrtimer_cancel(&pmu->hrtimer);
}
static void cn10k_ddr_perf_pmu_enable(struct pmu *pmu)
@@ -502,6 +524,92 @@ static void cn10k_ddr_perf_pmu_disable(struct pmu *pmu)
DDRC_PERF_CNT_END_OP_CTRL);
}
+static void cn10k_ddr_perf_event_update_all(struct cn10k_ddr_pmu *pmu)
+{
+ struct hw_perf_event *hwc;
+ int i;
+
+ for (i = 0; i < DDRC_PERF_NUM_GEN_COUNTERS; i++) {
+ if (pmu->events[i] == NULL)
+ continue;
+
+ cn10k_ddr_perf_event_update(pmu->events[i]);
+ }
+
+ /* Reset previous count as h/w counter are reset */
+ for (i = 0; i < DDRC_PERF_NUM_GEN_COUNTERS; i++) {
+ if (pmu->events[i] == NULL)
+ continue;
+
+ hwc = &pmu->events[i]->hw;
+ local64_set(&hwc->prev_count, 0);
+ }
+}
+
+static irqreturn_t cn10k_ddr_pmu_overflow_handler(struct cn10k_ddr_pmu *pmu)
+{
+ struct perf_event *event;
+ struct hw_perf_event *hwc;
+ u64 prev_count, new_count;
+ u64 value;
+ int i;
+
+ event = pmu->events[DDRC_PERF_READ_COUNTER_IDX];
+ if (event) {
+ hwc = &event->hw;
+ prev_count = local64_read(&hwc->prev_count);
+ new_count = cn10k_ddr_perf_read_counter(pmu, hwc->idx);
+
+ /* Overflow condition is when new count less than
+ * previous count
+ */
+ if (new_count < prev_count)
+ cn10k_ddr_perf_event_update(event);
+ }
+
+ event = pmu->events[DDRC_PERF_WRITE_COUNTER_IDX];
+ if (event) {
+ hwc = &event->hw;
+ prev_count = local64_read(&hwc->prev_count);
+ new_count = cn10k_ddr_perf_read_counter(pmu, hwc->idx);
+
+ /* Overflow condition is when new count less than
+ * previous count
+ */
+ if (new_count < prev_count)
+ cn10k_ddr_perf_event_update(event);
+ }
+
+ for (i = 0; i < DDRC_PERF_NUM_GEN_COUNTERS; i++) {
+ if (pmu->events[i] == NULL)
+ continue;
+
+ value = cn10k_ddr_perf_read_counter(pmu, i);
+ if (value == DDRC_PERF_CNT_MAX_VALUE) {
+ pr_info("Counter-(%d) reached max value\n", i);
+ cn10k_ddr_perf_event_update_all(pmu);
+ cn10k_ddr_perf_pmu_disable(&pmu->pmu);
+ cn10k_ddr_perf_pmu_enable(&pmu->pmu);
+ }
+ }
+
+ return IRQ_HANDLED;
+}
+
+static enum hrtimer_restart cn10k_ddr_pmu_timer_handler(struct hrtimer *hrtimer)
+{
+ struct cn10k_ddr_pmu *pmu = container_of(hrtimer, struct cn10k_ddr_pmu,
+ hrtimer);
+ unsigned long flags;
+
+ local_irq_save(flags);
+ cn10k_ddr_pmu_overflow_handler(pmu);
+ local_irq_restore(flags);
+
+ hrtimer_forward_now(hrtimer, cn10k_ddr_pmu_timer_period());
+ return HRTIMER_RESTART;
+}
+
static int cn10k_ddr_perf_probe(struct platform_device *pdev)
{
struct cn10k_ddr_pmu *ddr_pmu;
@@ -550,6 +658,9 @@ static int cn10k_ddr_perf_probe(struct platform_device *pdev)
if (!name)
return -ENOMEM;
+ hrtimer_init(&ddr_pmu->hrtimer, CLOCK_MONOTONIC, HRTIMER_MODE_REL);
+ ddr_pmu->hrtimer.function = cn10k_ddr_pmu_timer_handler;
+
ret = perf_pmu_register(&ddr_pmu->pmu, name, -1);
if (ret)
return ret;
--
2.17.1
More information about the linux-arm-kernel
mailing list