[PATCH v3 6/8] arm64: dts: ls1028a-qds: move rtc node to the correct i2c bus

[Li Yang]

From: Biwen Li <biwen.li at nxp.com>

The i2c rtc is on i2c2 bus not i2c1 bus, so fix it in dts.

Fixes: 8897f3255c9c ("arm64: dts: Add support for NXP LS1028A SoC")
Signed-off-by: Biwen Li <biwen.li at nxp.com>
Signed-off-by: Li Yang <leoyang.lil at nxp.com>
---
 arch/arm64/boot/dts/freescale/fsl-ls1028a-qds.dts | 14 +++++++++-----
 1 file changed, 9 insertions(+), 5 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a-qds.dts b/arch/arm64/boot/dts/freescale/fsl-ls1028a-qds.dts
index 00d5b81bdef3..baa1cc9b9835 100644
--- a/arch/arm64/boot/dts/freescale/fsl-ls1028a-qds.dts
+++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a-qds.dts
@@ -276,11 +276,6 @@ temperature-sensor at 4c {
 				vcc-supply = <&sb_3v3>;
 			};
 
-			rtc at 51 {
-				compatible = "nxp,pcf2129";
-				reg = <0x51>;
-			};
-
 			eeprom at 56 {
 				compatible = "atmel,24c512";
 				reg = <0x56>;
@@ -322,6 +317,15 @@ mux: mux-controller {
 
 };
 
+&i2c1 {
+	status = "okay";
+
+	rtc at 51 {
+		compatible = "nxp,pcf2129";
+		reg = <0x51>;
+	};
+};
+
 &enetc_port1 {
 	phy-handle = <&qds_phy1>;
 	phy-mode = "rgmii-id";
-- 
2.25.1